0
Add your answer:
Earn +20 pts
You have five chokes for your shotgun which is the best for pheasant shooting?
Modified.
Can the barrel of a browning double automatic be modified for invector chokes?
Yes
What are the symbols for beretta shotgun chokes?
* Full *- Improved Modified ** Modified **- Improved Cylinder **$ Skeet *** Cylinder Bore
Can steel shot duckloads be safely shot from Browning A-5 lightweigt 12 gauge shotgun?
only if your choke is improved cylinder or modified, full chokes are a no,no. the barrel will bulge or burst!
Model 50 glenfield 20gauge what would the barrel be slug or buckshot?
Either. In general, slugs can be fired through any standard shotgun barrel. An exception is for Extra Full Chokes, which are not standard. Best accuracy with slugs in probably modified choke.
Can you use buckshot in a choked shotgun barrel?
Yes chokes are designed to tighten shot patterns.
What is the standard choke for a browning sweet 16 with a t28 inch barrel?
There is no "Standard" choke. A5's could be purchased with one of many different chokes, however, the more common chokes on a 28" barrel were Full and Modified
Can you use a sabot slug in moss berg 930?
You can use a sabot in any shotgun, as long as the barrel is not choked. If you have screw in chokes, you will want to use ONLY the Cylinder or CYL choke. Otherwise, you will need to look on the barrel to see what it is choked in. If you do not have screw chokes, unless it says CYLINDER or SLUG, it is probably choked. (It may say Improved, IM, Modified, Full, etc)
How can you tell what a Steven 20 ga double barrel series H shotgun have for chokes in each barrel?
Break open the action and it should be engraved on the metal that is normally unseen when the action is close, that or it should be on the barrel. If the chokes are removable then it should be engraved on those as well.
How can you tell if shotgun is modified?
The question can have two meanings...if you are asking if the shotgun has a modified choke, usually it will say on the barrel if the choke is fixed (full, "imp cyl" for improved cylinder, "mod" for modified). If your barrel has interchangeable chokes, you just need to unscrew the choke tube and read what it says. If you are asking if it was modified from the factory configuration, modifications that aren't blatantly obvious (sawed off barrel or stock, magazine tube extension, shell holders, combat sights, aftermarket stocks, etc.), may be hard to tell, like a trigger job. For gross changes, have a factory picture and compare. Subtle modifications may be hard to tell.
Symbols for shotgun chokes?
M=MODIFIED IC=IMPROVED CYLINDER S=SKEET F=FULL Also, as stamped on receiver: * Full *- Improved Modified ** Modified **- Improved Cylinder **$ Skeet *** Cylinder Bore
On a Stevens 311 20 gauge side by side is there a way to tell if the chokes are full or modified?
yes, I have a 311a double barrel 20ga and the left barrel is a full choke and the right barrel is modified. I also have a Springfield 511 double barrel and the chokes are the same on it. If you look at the end of the barrel you can tell one of them is slightly smaller and that is your full choke, that would be the left barrel and the right barrel is modified. I hope that helps. Of course, if they are improved and open there will also be a difference in the measurements. Just take it to a gunsmith and ask him to check. If he has the gauges, it will take him less than a minute and he probably won't even charge you for it.
