0
How old is a 6-shot revolver with a swing out cylinder black plastic grips and the barrel markings SW Springfield Mass US 32 long 158781?
Wiki User
∙ 16y ago
Insufficient information to answer the question. Identify the item in question and resubmit.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What containers used to measure?
There's a graduated cylinder to measure liquid volume. It is a clear glass or plastic tube with mL markings on it.
Is a graduated cylinder similar to a measuring cylinder?
Yes, a graduated cylinder is similar to a measuring cylinder. Both are cylindrical containers used for measuring the volume of liquids. Graduated cylinders typically have markings to indicate volume measurements, while measuring cylinders may or may not have these markings.
What is the age and value of SW 32 long ctg serial 97555 with pat dating from 1894 to 1906 black plastic handles 6 shot revolver?
Need a detailed description of all markings.
How does one remove the cylinder retaining wedge from an 1860 Army Colt revolver?
tap the narrow part of the wedge with a piece of wood or plastic mallet. it should slide out.
Did rick springfield have plastic surgery?
no
What is a ruler with no markings called?
a bit of plastic
What materials is the revolver made of?
Steel, wood, plastic, brass
What is the value of a a Colt New Frontier 22 single action revolver with an LR cylinder and an extra 22 magnum cylinder set of plastic and wood grips with brown Hunter 1100G16 holster?
Mint condition, maybe $450. Value drops fast with wear. sales@countrygunsmith.net
Can you use metal shells in an airsoft revolver that comes with plastic shells?
No.
Where is the thermostat in the jeep compass?
There are two under the plastic housing on the driver side of the cylinder head.There are two under the plastic housing on the driver side of the cylinder head.
How do you make bb's?
melt plastic from a plastic melter gun shape it into a cylinder
How do you disassemble a smith and Wesson model MP?
A Smith and Wesson M&P model is a 6 shot revolver in 38 Smith & Wesson Special caliber. The MP or M&P stands for "military and police".To disassemble the revolver, first remove the grip screw from the left side of the revolver as the revolver barrel faces to the left.When the grips are removed the side plate will be fully visible.Remove the screws from the side plate.To remove the side plate, hold the revolver to the horizontal position with the side plate facing down. Do not pry off the side plate as that will damage the side plate fit.Sharply rap the now exposed grip frame with a wood or plastic hammer until the side plate loosens. Continue to rap, and the side plate will fall off along with the hammer block, so be sure it falls on a padded surface.At this point most internal parts will be visible and accessible.The cylinder can be removed by sliding the cylinder crane to the left and out of the frame, while holding the cylinder in place.The cylinder will now be free.To reassemble the revolver, do the above in reverse, making sure the hammer block is in place and the side plate seats correctly.You can tap on the side plate with a wood or plastic tool to seat it properly.Replace the cylinder crane and cylinder. Be sure the correct screw is used to hold the cylinder crane to the frame.Replace the remaining side plate screws in the correct place along with the grips and grip screw.Holding back the hammer slightly, or with the hammer cocked, look in the gap between the hammer and frame to be sure the hammer block has been replaced.A word of caution here: know exactly what you are doing before making alterations or repairs. Revolvers are delicate and expensive machinery.
