Yes, it is possible to gradually return to the slow down time
The pool return line is the one that returns the water form the filter to the pool. Usually you'll see holes in the side walls of the pool with little eyeball sockets where the water flows back to the pool.
fast
No specified pressure at the "return" fittings at pool side. You do not measure pressure at these points.
To install the water return fitting above the ground pool, you have to switch off the source. After this you can then install the water.
Return fittings
There are just a few easy actions you need to take to get the water from your pump back into the pool. Before anything else, check that the pump is wired in and primed. Make sure there is nothing clogging up the pump basket. Find the pool's water return inlet and proceed to the next step. This is a fixture that is typically installed on the pool's wall. Pool hose of an appropriate length should be attached to the pump's discharge port. The pool's return inlet should be connected to the hose's opposite end. When you're ready, activate the pump. After a while, water should start trickling through the hose and into the pool. Check for leaks in the plumbing and make sure the water is flowing freely. If the water flow rate is too slow or too fast, you can adjust the pump's settings. Proper water circulation and filtration rely on routine pump and pool equipment maintenance.
first you have to find the magma leader.then you return where the magma pool guards. Answer by:Paxlux
you are going very slow
Foam in a pool that uses Baquacil can have a leak in return hose. It can also be the result of putting too much product in the pool. You should check the chemical levels in the pool.
Like most things in life, "it depends"! Yes, one return jet can be sufficient for an above ground pool or a smaller in-ground pool, maybe up to 15,000 gallons or so. But most large in-ground pools have multiple return lines to reduce the size of the returns and improve the circulation. If your pool has moveable return fittings that let you direct the return stream, it is most common to point them down towards the bottom to improve bottom to top circulation (since the skimmer takes water from the top, its best if you return water towards the bottom).
Yes there is no reason why not.