I suggest you contact the manufacturer of the algaecide and find out from them what would be the bes coarse of action.
Vaccum the algaecide and its treated remainder to WASTE. Keep testing until it is ok. It should be fine. You may also call the company who makes the algaecide to get their suggestions. When I had a problem with my pool about three weeks ago, the pool company put a LOT of algaecide in the pool and then I vaccumed it to waste. Now I put just the minimum in each week to prevent algae from growing.
By killing the green algae with an algaecide available at your pool shop.
Adding algaecide to the pool when the filter is on should not do any harm in fact it should mix it into the water more quickly
my pool did get milky but cleared up after 48 hours
You want to have the equipment running while adding any chemicals. You will want to wait about an hour after adding algaecide.
add a poly 60 or a 7% copper based algaecide if you dont have a heater on the pool.
the same as before. whoever told you that you didnt have to shock and use algaecide lied. the same as before. whoever told you that you didnt have to shock and use algaecide lied.
Read the label, but usually it is safe. Pool Masters
Too much algaecide in a pool can lead to skin irritation, eye irritation, respiratory issues, and allergic reactions in humans. It's important to always follow the manufacturer's instructions and guidelines when using algaecide to prevent overexposure.
Chlorine and Algaecide, and flocculate then when the algae is dead vacuum it to waste from the bottom of the pool. ( Follow the instructions on the containers)
A person can make a homemade pool algaecide by combining bleach, baking soda, and Borax. This shocks the pool and increases the pH if needed.