0
Add your answer:
Earn +20 pts
Why use skimmer door?
Your skimmer door is called a weir. A weir is a pivoting flap, door or dam in a skimmer that keeps bugs and leaves from re-entering a pool or spa by collecting the debris in a basket while letting water recycle through the filter system.
What causes the skimmer door not to open?
You might have debris stuck between the wier and the skimmer mouth. Or your deck or bond beam may have shifted slightly causing the wier (skimmer door) to stick. You might be able to shave a little off the sides of the wier to allow it to work.
Inground fiberglass pool skimmer leaks needs repair or replacement?
It would be easier to replace with a floating skimmer Check poolrite dragonfly
Is there any kind of repair kit for a rusted pool wall around your through wall skimmer?
If this is an above ground pool you could just pull the old skimmer out cut the rusted section of metal out hit it with some rust converter, replace the section where there is no metal with a new metal forget about the old skimmer setup and replace it with a "floating pool skimmer" they do a better job any way.
How do you get more suction in skimmer for pool vacuum?
you may have to prime your pump Clean or replace the filter.
How do you replace the headlight on a 1997 Porsche boxster?
poo
How do you repair PVC pipe connection to the skimmer on your in ground pool?
Dig it up and replace the leaking section.
How do you replace interior door courtesy lamp?
How do you replace interior door courtesy lamp?
Does water leak out of pool skimmer?
here is how I did it - I built a box out of wood big enough to cover the skimmer area . I built mine out of scrap wood. I then covered the edges of the box with foam window seal to give it a good seal. Place the box over the skimmer area. When you start you will only lose the water inside the box and the water pressure will seal the area. Replace skimmer, remove box.
Can you replace the skimmer without replacing the liner?
Yes you can. Drop the waterline in the pool below skimmer level, dig a whole around your skimmer to gain access. Unscrew the skimmer faceplate and remove it as well the old gasket. You also have to remove the second gasket between liner and wall. Detach the pipe(s) from the skimmer. Now install the new skimmer by attaching the pipe(s) to the skimmer put new gaskets in place screw the faceplate back on and you're done. Don't forget to fill your hole again and put water back in the pool to the appropriate level. ;-) Jens Poseidon Pool Services, Dunrobin, ON
What is a skimmer weir?
A skimmer weir is the plastic flap and the opening of the skimmer. It traps leaves that are pulled into the skimmer when the pump is running and then holds the leaves in the skimmer whne the pump shuts down
How do you replace an interior Ford Fusion door handle?
To replace interior Ford fusion door handle you must remove the door panel, take off the old handle and replace with the new one, and then replace the panel back on the door frame.
