Depending on what the repair consists of you can actually do most pebble tec surface repairs yourself, you just need a chisel and a hammer and a little skill to read directions and the ability to use a small trowel. you can research pebble tec patch kits on the internet and find a kit that matches your color.
It's really pretty easy to do with a little skill you can chip away the old surface, make some scratch marks on the pool beam or surface, I imagine when you say "exposed edge" you mean the "rolled bond beam". The best thing to do is pick up a pebble repair kit of your color and test out your skills at the repair.
yes
SCP usually has it in stock you can reach them at www.scpool.com If you need installation contact Scuba Pool Repair- Repairing your pool Underwater: 800.330.7068 or visit www.scubapoolrepair.com
Dry ice can damage pebble tech surfaces in pools due to its extreme cold temperatures. The rapid temperature change can cause the surface to crack or delaminate. It is best to avoid direct contact between dry ice and pebble tech surfaces to prevent any potential damage.
I doubt it and if it worries you, fill the crack with a cement grout mixture,
Any pool Interior finish will dry out and crumble if allowed to do so.
To clean sand-colored pebble tech on the coping area, you can use a mild soap and water solution with a soft brush to scrub the surface. Avoid using abrasive cleaners or tools that may damage the pebble tech surface. Rinse thoroughly with clean water after cleaning.
Pebble tech
There is a web link describing quarts finish below. There is also a web link on pebble tech below. pebble tech and quarts are pool surface finishes (see the links mentioned above) Wet edge is a method of constructing a pool where by one or more edges of the pools side are built just below the waters natural surface height. This brings about a situation where water is constantly falling over the edge of the pool into a balance tank and then via filtration back into the pool.
ITC tech engernering tech cad cam
The smallest type of rock is a pebble. A pebble can be made out of most rocks and is the size of a marble.
Drop the water below the cracks. Remove loose cement and texture down 1/4 inch. Mix the Pool Pebble Repair compound. Apply the compound to the crack and wipe off excess. Allow to cure for 12 hours.
brush it with a strong solution of acid, Becarefull for your eyes ETC and then hose it down.