answersLogoWhite

0


Best Answer

Replace the pump seal. This is a friction seal and will need to be replaced periodically, however the more common cause of seal failure is running the pump without water. The water running through the pump is what keeps the seal cool and functional.

If the pump has been run dry for any substantial length of time there may also be heat damage to other components of the pump. The rear seal plate, the impeller, the diffuser, even the entire pump housing can be heat damaged depending on the model of pump and how long it ran dry.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you fix a leak at the shaft of a 5060 Hayward booster pump?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Bad brake booster?

A bad brake booster will cause a vacuum leak, result in poor braking, and even poor engine performance. The brake booster has a large diaphragm which can fail and leak.


What causes the engine to cut off when you apply the brake?

Perhaps a vacuum leak check power brake booster for leak and also inlet check valve on booster


Can you be able to brake with a vacuum leak in the brake booster?

If the vacuum leak is small, then yes the brake booster will still function well enough to assist the braking action. However, if the vacuum leak is very large, or if the brake booster rubber diaphragm is ruptured , then the brake booster will be inoperative and you will NOT have power assist to the brakes. It's wise to just replace the power brake booster with a new unit if there is an internal leak in it, to avoid an accident due to a loss of braking power.


Why would the breaks be hard on my 1994 camaro z28?

BAD power brake booster are a vaccum leak at the booster.


How can you fix the fluid leak of a 1991 Jeep Wrangler manual transmission The leak seems to be from the drive shaft.?

The rear, or tail shaft, of a transmission has a seal around the output shaft. The drive shaft will have to be removed and the seal replaced.


What are Symptoms of an input shaft leak?

If you mean dripping out of the of the tranny where the shaft slips in then the leaking is it


What if your 93 buick lesabre releases air when you step on the brakes?

You may have a vacuum leak at the brake booster. Have the brake booster inspected.


What would cause a Jeep Comanche to stall when preass ing the brake?

brake booster vacuum leak,or bad brake booster.


What is causing the hissing sound when you step on the brakes?

Sounds like it could be a vacuum leak at the power brake booster Check the lines to booster and the check valve at the booster Could be a defective brake booster also


Can an ac clutch leak freon?

No, the leak is propably the compressor shaft seal which is behind the clutch.


Why is your brake pedal on Ford Falcon AU hissing?

it is hissing because there is a vacume leak in the brake booster it will require a new brake booster


Will drum brakes on a Honda CRX 88 cause the car to stall?

no, but having a vacuum leak at the power booster will. IF so, you will have to replace the booster.