answersLogoWhite

0


Best Answer

i dont know sorry

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why was cole Matthews facing an entire year alone in southeast Alaska?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the duration of Man Facing Southeast?

The duration of Man Facing Southeast is 1.75 hours.


When was Man Facing Southeast created?

Man Facing Southeast was created on 1986-09-09.


What direction do southeast winds blow from?

Wind direction is always given as the direction from which it is blowing. If there is a southeast wind, it is coming from the southeast, and facing "into it" would have you facing southeast. Many meteorologists will clarify this by saying "winds are out of the southeast."


If you are facing northwest you make a halfway clockwise?

Whichever way you turn, you'd be facing southeast.


You are fracing north if you turn 135 degrees clockwise what direction are you now facing?

Southeast


What is the danger facing the rain forests of south and southeast Asia?

Lumber companies are destroying their habitats.


If you are facing north and you do a quarter turn clockwise what direction wil you be facing?

Southeast


What is the lowest point of Mt McKinley?

Mount McKinley is located in Alaska facing Wonder Lake. The lowest point of the mountain is at sea level in the Gulf of Alaska, the Bering Sea, and the Arctic Ocean.


When the entire side of the moon facing the earth is bathed in the sunlight the moon is?

In alignment with the earth and sun.


Phase when the lighted side of the moon is facing the sun and the dark side faces the earth?

The lighted half of the moon is always facing the sun. The entire dark half of the moon is facing earth at the time of "New Moon".


When the entire side of the moon facing the Earth is bathed in sunlight the moon is said to be a?

That's a "Full Moon".


Why do you disturb the centers of a lathe machine during turning and not facing?

During the facing process of a workpiece over its entire face, the center is not required and is not set into the workpiece, therefore no forces are present on the center.