You fix
The answer depends on what is wrong with the cube and needs fixing.
a unifix cube is a little cube shaped block that children have been known to play with. it has holes all around it except on one side which has a nob. it is kind of a form of lego.
The most common reason a Game Cube will freeze is that the disc is dirty. To fix this problem, turn off the console and remove the disk. Clean the disk and then return to console. The game should work just find after cleaning.
my game cube memery card isent working theres no hole on the computer and i said to formatting and it faild how do i fix it
you use acohole and cotten ball and pour the acohloe into the cotten ball and rub it across
Many types of adhesive are used on labels: permanent; peelable; ultra peel; frost fix; marine; and security are the most common types of adhesive that are used.
the voltage reg should be built in the alternator. if it won't charge,find the little red wire on the rear of the alternator,cut the side off of it,do not clip the wire,just peel the red coating off of it,get another piece of wire,peel it,wrap it around the red wire,and run it to the hot post of your battery. this is only a temporary fix. if your alternator is working it will charge your battery,however it will over charge. IT IS ONLY A TEMPORARY FIX UNTIL YOU CAN GET IT INTO A SHOP!!!
Yes if you really want to, but if being scraped at, or hit with something the paint will peel and reveal the tile's true color underneath. Overall, not the best idea, but it works in a quick fix.
You can fix it if only the pieces fell off, but if a center square broke off, well, that's a lot harder, and you might possibly have to buy a whole new one. However, if you just need to put the pieces back, you should start with an edge piece and put it in place. NOTE: PUT IT TOGETHER SOLVED OR IT WILL MOST LIKELY BE IMPOSSIBLE. To put an edge piece into place, slip it under two center pieces by the protruding sections so it looks like a normal cube edge. Then put another edge piece in right next to it (between two center squares). Next, you need to slide the right corner piece in between the two edges you already put in, making sure the right color is facing down. Next, slide the right edge piece on top of the corner. This should have a 2x2 block on one corner.Continue to put pieces in place on another corner of the cube center. You should put all the pieces on all but one side on. The last side is a bit tricky. To get an edge piece on, you will have to snap it into place instead of sliding it in from the side. Snap the pieces into place in this order:p.s. you should put an edge piece in last, not a corner.-------------| 7 | 1 | 2 ||---|---|---|| 8 | x | 3 ||---|---|---|| 6 | 5 | 4 |-------------NOTE: THE CUBE IS VERY UNSTABLE WHILE SOME PIECES ARE OUT OF PLACE. TAKE CARE NOT TO BUMP IT AND *CRASH* AND HAVE TO START ALL OVER AGAIN. :)
Depending on how bad it is, it can either be wet sanded (using a fairly hard rubber block) with 2000grit paper and buffed, or the the same process with 600-800 paper and then re-painted. Remember , most mass-produced cars have some orange peel in their paint, and it takes a skilled painter to re-produce it (such as in a repair) to match it to the rest of the car.
There is really is not much you can do. Supposedly there are various things that you can add to absorb the salt, such as potatoes, but I do not think they work and they all cost money. My advice is to eat it as is, if you can or throw it out and learn from your mistake.