How do you break into a Rubik's Cube?

Answer 1

1.) twist one side (it doesn't matter which one) so the corners stick out. 2.) use a flat screwdriver to pry it out. (put it under the edge piece and pry toward the rotated side)
3.) take the corners out through the gap you left.
4.) from then on, it kinda falls apart. Just help it.
NOTE: the centers don't come out.
I ALSO THINK YOU WILL NEED THIS INFO:
To put it back together, do:
1.) fit one edge piece in their right place between the centers.
2.) fit the other edge piece in it's right place next to the one you just put in.
3.) slide the right corner in it's place in between the two edges you put in.
4.) continue doing this until you are almost done. MAKE SURE AN EDGE PIECE IS LAST! fit the last edge piece in the same way you took it out. it may help to rotate it the way i said above.
IMPORTANT!!!!!!!!!!!!! PUT IT BACK TOGETHER SOLVED! IT MIGHT BE IMPOSSIBLE TO SOLVE IF YOU PUT IT BACK TOGETHER RANDOMLY!


Hope I helped.

Answer 2

just randomly twist it. I recommend doing FURURF until it is scrambled. -=]

There are many methods for you to solve (unscramble) it... You should try the Beginner Method first.. after you get it to average of somewhere around a minute, look for other, more advanced methods like Heise Method, Lar Petrus Method, etc etc

Answer 3

Ok, Heres hows to do it: Turn the top layer 45 degrees and poke something like a knife under the middle cube and push the handle of the knife down and the middle cube should come out and then pull the corners out etc etc.

Answer 4

You turn the top of the rubix cube and get a screwdriver and pull up on the side where its black :D

Answer 5

twist 1 side 45 degress and PUSH UP REALLY HARD on one corner. this method only works on a Rubik's 2x2x2 cube

Answer 6

Its impossible. Unless your friends are dumb.