0
Add your answer:
Earn +20 pts
What is a shower roughen?
A shower rough-in usually refers to the distance from the wall to the center of the shower drain , measured out away from both walls in a shower to the center of the drain. It also maybe referring to the height and the center line of the placement of the shower valve.
What is the maximum allowable distance of a shower drain to trap if you are remodeling a shower and need to move the drain seventeen inches to center it?
It cant have more than 3 feet of length on it
Hwy when you flush your upstairs toilet does your downstairs shower drain erupt sewage?
The drain from the toilet to the main drain is plugged and the branch to the shower is not. If the main floor toilet flushes, it is between the two toilets and not between the house and the sewer.
When installing a shower drain in a concrete floor how do you determine the height of the drain which will protrude through the concrete?
First determine what you are going to install as the shower unit. If there is to be no shower unit and it will just drain through the concrete floor, then it will be flush with the floor. If you are installing a unit, then you need to look at the unit to determine the distance obove the concrete to place the drain.
Is the shower drain has a ubend or straight pipe?
Shower drain goes into a trap under shower. Continue piping from trap to drain line.
How do you know if shower pipe is clogged?
Water won't drain from shower. Either trap or shower drain line is clogged.
What is the difference between a drain and a sewer?
the sewer is where things that you flush or put down the drain go, a drain is the opening is a sink or shower that sends things to the sewer
Could bowel movements in the shower plug shower drain?
YES.
What is the size needed for a shower drain?
typically shower drains are 2"
What are the steps to make a complete shower after the drain is set?
The center of the shower floor where the tile shower drain would normally be positioned ... drain base. After this step the sloped mortar bed should be ... pan liner or membrane in our instructions.
How do you fit a shower drain assembly to a 2 inch shower waste pipe which is about 10 degrees off vertical so that the shower drain will be horizontal in the shower pan?
Possibly a caulked joint ( lead and oakum )
Is the toilet drain pipe a big job to move and can you use a shower drain instead?
This can be a complicated job as the toilet drain ranges from 3" -4" and a variety of materials from Plastic to cast iron to galvanized. Then there is the venting to consider and NO a shower drain CANNOT be used for a toilet discharge as the shower drain is normally 2" diameter
