It attaches to throttle plate (next to throttle cable) to cruise control unit.
Look on the throttle body where the throttle cable connects. There is a separate cable next to it. Follow that back to a round unit about the size of half of a soda can, that is the servo.
"Double-pole" refers to the type of switch used to disconnect the cooker from the incoming household electricity supply. Only by using a double-pole switch can the cooker's connections to both the live (or "hot") and neutral supply wires be switched on and off simultaneously.
yes you can as long as its the same size as the original
The mechanism is on the passenger side of the heater unit a couple inches back on the right side. It is connected by cable to the control unit on the dash in the vent setting. If it doesn't work, it is likely one of the clips securing the cable to the heater housing, or the control unit, is damaged. If you do not need the vent, then disconnect the cable from the lever on the heater unit and manually close it using the lever. Kind of a tight spot but easily done. Otherwise, you must replace the cable. Good luck finding one as they quit making them.
This unit requires a PWM power supply.
Well, we'd need to know voltage, amperage, material used in the wire (copper or aluminum), and the length the wire will extend from the power source.
It does not use a cable. The heater blend door is operated by a electric motor. The complete dash assembly needs to be removed to gain access to the unit.
This unit will require the PWM power supply system
To change the positive battery cable on a 1988 Jeep Cherokee trace the end of the cable to the starter. Unplug the battery then remove the cable from the starter. Measure the old positive cable with the new and be sure to replace the unit at the right size.
To answer this question the voltage of the unit must be given.
7.2kW shower = 32 Amp fuse = 6 mm2 cable size7.5kW shower = 40 Amp fuse = 10 mm2 cable size8.5kW shower = 40 Amp fuse = 10 mm2 cable size9.5kW shower = 40/45 Amp fuse = 10 mm2 cable size10.5kW shower = 45 Amp fuse = 16mm2 cable size