0
Add your answer:
Earn +20 pts
What is another plumbing term for MJ Bend?
Mechanical Joint Bend
Why doesn't boys bend down to use the toilet?
Because of differences in plumbing it's easier not to, if urinating. If defecating, they do bend down.
What is bend pipe?
pipe bending is a method to enhance the fabrication capabilities of pipe work and plumbing fixtures
services:?
Toilet Plumbing, Affordable Plumbing, Commercial Plumbing, Emergency Plumbing, Shower Plumbing, Plumbing Leak Detection, Plumbing & Heating,
Our Plumbing Services :-?
Water Heater Water Heater Installation Water Leak Repair Emergency Plumbing Affordable Plumbing Commercial Plumbing Toilet Plumbing Shower Plumbing Plumbing Leak Detection Plumbing & Heating Plumbing Pipes
What are some terms used in plumbing?
In plumbing, a trap is a U-, S-, or J-shaped pipe located below or within a plumbing fixture. An S-shaped trap is also known as the S-bend invented by Alexander Cummings in 1775 but became known as the U-bend following the introduction of the U-shaped trap by Thomas Crapper in 1880. The new U-bend could not jam, so, unlike the S-bend, it did not need an overflow. The bend is used to prevent sewer gases from entering buildings. In refineryapplications, it also prevents hydrocarbons and other dangerous gases from escaping outside through drains.The most common of these traps in houses is referred to as a P-trap. It is the addition of a 90 degree fitting on the outlet side of a U-bend, thereby creating a P-like shape. It can also be referred to as a sink trap due to the fact it is installed under most house sinks.Because of its shape, the trap retains a small amount of water after the fixture's use. This water in the trap creates a seal that prevents sewer gas from passing from the drain pipes back into the occupied space of the building. Essentially all plumbing fixtures includingsinks, bathtubs, and toilets must be equipped with either an internal or external trap.Because it is a localized low-point in the plumbing, sink traps also tend to capture heavy objects (such as jewelry) that are inadvertently dropped into the sink. Traps also tend to collect hair, sand, and other debris and limit the ultimate size of objects that will pass on into the rest of the plumbing, thereby catching over-sized objects. For all of these reasons, most traps can either be disassembled for cleaning or they provide some sort of cleanout feature.
What is plumbing top out?
Plumbing top-out is the stage of plumbing that occurs when a home is in its frame stage. There are three stages of plumbing typically in construction. Plumbing rough (prior to the foundation being poured); plumbing topout (bringing ground plumbing up through the vents); plumbing trim (installing fixtures).
The Plumbing Houston?
The Plumbing Houston
What is underwater plumbing?
Plumbing underwater
Plumbing Bellaire?
Plumbing Bellaire
The Plumbing Bellaire?
The Plumbing Bellaire
Plumbing Of Humble?
Plumbing Of Humble
