Different instructions appear to apply to different models, so two versions are offered:
OPTION 1:
Press and hold the MODE button (bottom left) for approximately 3 seconds.
When the Alarm set time starts flashing, press the MODE button once more. Now the seconds for the watch time should be flashing.
Use the START/STOP button (top right) to move between items and the SPL/RESET button (bottom right) to change the item.
Moving between all items, it will take you through: seconds, minutes, hours, month, date, day of the week. Simply press MODE when your settings are complete.
Remember to make sure that you hold down the MODE button for a sufficient length of time.
Read more: How_do_you_change_the_time_on_a_digital_Indiglo_AQUA_WR50m_watch
OPTION 2: (For model CR1620, and others that do not reset when MODE is held down)
Be sure you are in the hour/minute/second mode (press MODE until you are in the right screen).
Press and hold the SET button (top left) for approximately 3 seconds. The seconds number will start flashing.
Press the MODE button; the hours number will start flashing. Press the START/STOP button (top right) to increase the number, or INDIGLO button (lower right) to decrease the number as desired.
Press MODE again; the minutes will flash. Increase or decrease the number by using the right side buttons, as above.
Pressing MODE repeatedly will take you through additional settings, if desired (month, date, day of week).
Press SET to lock in the desired numbers. The seconds stop flashing when you are out of the reset function.
The bottom left button is the mode button. Push it once and release, this will take you to the alarm time. Again if you push in the button a second time and release, the seconds on the clock time will begin flashing. The top right button changes the seconds. Hold in the bottom right botton until the minutes start flashing, then release. Again use the top right button to change the minutes. Use this same procedure to move on to the hours, then the date, etc.
Press the MODE button multiple times until the current (wrong) time shows up with the seconds flashing. Then press the RESET button until the minutes flash. Change the minutes by pressing the START button until the correct minutes are showing. Then press the RESET button once and the hours will flash. Continue through all settings. You can reset the seconds to zero by pressing the START button while the seconds are flashing.
If the buttons on a 3 button digital wrist watch are corroded then it is almost impossible to change the date and time without having the watch fixed.
You pull out the crown once to change the date, twice the change the time
There is no digital watch that adjusts to time zone.
To change the time on a Fyzz watch, usually you would pull the crown (the dial on the side of the watch) out to its second position and then rotate it to set the correct time. Make sure to push the crown back in once you have adjusted the time. If you have a digital Fyzz watch, refer to the user manual for specific instructions on changing the time.
Mode refers to the current set of functions. For example, on a digital watch, in time-setting mode, a specific button will change the hour; change the watch to stop-watch mode and that button might start the timing.
depends on the watch.
it shows the time
you would have to hold the st/stp, mode and then the adj button altogether at the same time to to hear it beep then it will change back to regular time...
you would have to hold the st/stp, mode and then the adj button altogether at the same time to to hear it beep then it will change back to regular time...
To change the time on your wristwatch, locate the crown on the side of the watch and gently pull it out to the farthest position. Turn the crown clockwise or counterclockwise to adjust the time to the correct hour and minute. Once the time is set, push the crown back in to its original position to finish the adjustment.
how do i change the time on a watch
Press the 'spl/ret' button (2), hold down then press 'mode' (3) should change for you.