The difference between a cross cable and a state cable is that a cross cable, or crossover cable, is used specifically to connect two of the same devices.
You can't tell from just looking at it. You will have to use a special tool or a volt meter. Connect terminals of multimeter to the first pin on both sides in resistance mode. If you get reasonable reading then you have straight through otherwise it is cross-over.
neither, you need a rollover cable
EIA 568A/B standards apply.
1. straigth cable are more effective than the crossover cable....
Cross section is the surfave area of the cable if you imagine it cut into ... gauge and diameter are basically the same thing, although the unit of measurement are different.
Straight Cable is used to connect a device to a different type of devices Eg: PC to a Switch PC to a Hub Switch to a Router E.t.c. Cross Cable is used to connect a device to a similar type of devices Eg: PC to PC Switch to Switch E.t.c.
You need to use a straight type of connection. 568A or 568B depending which type your network is using.
what are the difference between clustering and cross enrollment
difference between cross section and block daigram
Question b main kru aur answer b,,to tum log kya kroge,, nikkamo
A straight through cable goes as follows on both ends:orange-whiteorangegreen-whiteBlueBlue-whiteGreenBrown-whitebrownA cross over switches green and orange so it would be as follows on the other end:green-whitegreenorange-whiteBlueBlue-whiteOrangeBrown-whitebrown