Wiki User
∙ 14y agoyou can, it all depends on the type of laser.
Wiki User
∙ 14y agoThe laser beam is a narrow, coherent beam of light that doesn't scatter much in clean, clear air. So, it's not visible unless there are small particles in the air, like fog, chalk dust, or mist, that scatter the light and make the beam visible.
No, a laser beam travels in a straight line through air unless it reflects off a surface. The direction of a laser beam can be altered by using mirrors or prisms, but it does not change direction on its own in mid-air.
Laser beams are typically invisible to the human eye because they emit light in a very focused and narrow wavelength, often in the infrared spectrum. The lack of scattering and diffraction in laser light prevent it from being visible unless it interacts with particles or surfaces in its path.
A laser beam is usually invisible to the naked eye. However, if there are particles or dust in the air, the beam may scatter the light and become visible as a thin line. Another way to see a laser beam is to use special goggles or a camera that can detect the specific wavelength of the laser.
One way to demonstrate that light travels in a straight path is by using a laser pointer. When you point the laser at a wall, the light beam will create a straight line from the laser to the wall. This shows that light travels in straight lines unless it encounters an obstacle or is refracted by a medium.
A laser light appears as a bright, focused beam of light that is usually a single color such as red, green, or blue. It is coherent and does not spread out like the light from a flashlight, creating a sharp and visible line across surfaces.
No. what happens when you point a laser at a wall? it just keeps going ,a light saber stops. unless you make some-thing to stop a laser beem hafe way then no you cant.
There is no ignition module in a '84 laser. They have a coil and distributor unless it has been modified. If you don't get a spark across the points in the distributor when you try to start the engine you probably need a new coil.
don't its illegal unless you have a licence
Once you activate the laser sight, basically where the laser is pointed is where the bullet is going to go.
A beam of light is scanned across the printer's photoreceptor. The harmless light beam is what the word laser is referring to.
Nothing really. Unless you got a deathwish then let the laser do the job...
The most important laser pointer components is the laser module . The costs for different colors of laser are different , about 1$ for red laser , 10$ for green laser and 200$ for blue laser . And the costs are keep going down.
You don't, unless you get the laser treatments to burn it out, big bucks.
The days of a good static bubble level seem to be a thing of the past, with the introduction of laser levers to carry out the task.The fixed laser lever throws light against the wall and the floor, whereas the rotating laser lever is set up preferably on a tripod in the middle of the room, where it can throw a chalk line laser light on all four walls at once and in advanced mode ceiling walls and floor together.
Laser? A laser burns tissue and is used in surgery, but not on a normal every day thing could it be used for family planning unless there is some new device I haven't heard about.
An Alpec 4604 laser is a pointing device used for presentations. To convert this to a burning laser is illegal unless properly licensed. Lasers are valuable tools especially for surgeons.
Yes, laser lights can potentially damage the eyes if they are powerful enough and focused directly into the eyes. Exposure to high intensity laser light can cause vision impairment or even permanent damage to the retina. It is important to use caution and protective eyewear when working with lasers to prevent eye injuries.