Sure, here's an example sentence using the word "kilowatt": "The air conditioner uses 2.5 kilowatts of power per hour."
The Huntley power station uses coal and gas to produce electricity.
Solar power uses photovoltaic cells to convert sunlight into electricity, while wind power uses turbines to convert the kinetic energy of wind into electricity. Solar power is dependent on sunlight, whereas wind power is dependent on wind speed and consistency. Both are renewable sources of energy, but they rely on different natural elements for generation.
The energy consumption of a blender can vary depending on its size and power rating. On average, a typical household blender uses around 300 to 1000 watts of power when in use. This translates to approximately 0.3 to 1 kWh of energy consumption per hour of operation.
tyrant
Sprinter uses high power and short time, while a marathoner uses low power over a long time.
The heater uses 1000 watts of power at every instant it is running. If it runs for 1 hour, it uses 1000 watt-hours of energy. That is called a kilowatt-hour or a Unit. So it it uses 1 kilowatt-hour per hour.
Hybrid cars get their power from the engine. When you went pass 30 miles per hour, it uses gasoline that is stored in the car. When it is going less than 30 miles per hour, it uses electricity from the engine to power the car.
The bulb's power, 75 watts, is the power it uses continuously all the time it is switched on. The energy it uses can be measured in watt-seconds (Joules) or in watt-hours. A 75 watt bulb uses 75 watt-hours each hour, which is 0.075 kilowatt-hour.
A 100 watt bulb uses 0.1 kilowatt (100 watts / 1000) per hour. At 15p per kilowatt-hour, the cost of running the 100 watt bulb for an hour would be 1.5p (0.1 kW * 15p).
A 40 kilowatt bulb consumes 40 kilowatt-hours of energy in 1 hour. This means it uses 40 kilowatts of power for one hour (40 kW x 1 hour = 40 kWh).
look at the panel on the back near the line cord. or the manual. But time is not a factor. If it uses 50 watts, it uses that power for 5 minutes, an hour, a week.
Power = energy / time Energy = power x time If you operate an electrical appliance for a while, then the amount of energy it used is (power it uses when it's turned on) times (length of time it's turned on). (power) x (time) is the amount of energy used. That's what you're billed for, and what you pay your local utility. Turn on a 1-KW appliance, and run it for 1 hour, it uses 1 kilowatt-hour of energy, and that's what you'll pay for.
not much but it needs to charge ........................................................................................................................................................................................................................................................................ not much but it needs to charge ........................................................................................................................................................................................................................................................................
the sourceA+
ECT stands for Electronically Controlled Transmission. Basically the transmission uses information gathered from the engine and the loads on the transmission and then sets the shift speed on the transmission.
The measure of the electric power an appliance uses is called wattage. It is typically expressed in watts on the appliance's label or specifications. The wattage helps determine the energy consumption and cost of operating the appliance.