0
Gold typically responds best to frequencies between 30-60 kHz, with some detectors even able to operate at higher frequencies. It is important to use a detector specifically designed for gold prospecting as they are tuned to these specific frequencies to improve detection capabilities.
Add your answer:
Earn +20 pts
How do you calculate frequency when given a half wavelength?
To calculate frequency when given a half-wavelength, you first find the full wavelength by doubling the half-wavelength value. Then, use the formula frequency = speed of wave / wavelength to find the frequency of the wave.
How do you find frequency for waves?
To find the frequency of a wave, you can use the formula: frequency (f) = speed of the wave (v) / wavelength (λ). The frequency is measured in hertz (Hz) and represents the number of complete wave cycles that pass a point in a given time period.
How do you find period of frequency?
The period of a frequency is calculated by taking the reciprocal of the frequency. In other words, period = 1 / frequency. This means that the period represents the time it takes for one complete cycle of a waveform at a given frequency.
How do you calculate light wavelength to frequency?
You can calculate frequency from wavelength using the equation: frequency = speed of light / wavelength. The speed of light in a vacuum is approximately 3.00 x 10^8 meters per second. By dividing this speed by the wavelength of light in meters, you can determine the frequency in hertz.
How do you find frequency of diffracted waves?
To find the frequency of diffracted waves, one can use the formula: f_d = (v_sound / λ_d) where: f_d is the frequency of the diffracted wave, v_sound is the speed of sound in the medium, and λ_d is the wavelength of the diffracted wave.
Where is the best place to find gold?
You can find gold in rivers, caves, and mountains but the best place to me is in the mountains.
Where can you find a ton of gold?
The best place to find a ton of gold is probably in the gold vaults of Fort Knox, Kentucky.
Where is the best spot to find gold?
In a mine.
When is the best time to use a frequency table?
The best time to use a frequency table is when you have disorganized raw data, that need to be sorted, usually to find trends in the data.
What is the resonant frequency of gold in hertz?
Previous answer: 1,729 MHz There is no "resonant frequency" of gold. Gold does have an NMR frequency, which is 1.729MHz. All NMR frequencies are dependent on the ambient magnetic field, and gold's 1.729MHz is valid for a magnetic field of 2.35 Teslas, which is 45,000 times stronger than a typical Earth field strength. But there is no resonant frequency which, if you broadcast it, will cause gold to resonate.
Where would you Usually find gold?
Finding gold is hard without technology but, the best places to find gold are in, lakes Rivers, creeks ,and jewelry shops.
Which jewellers gives the best rate on gold exchange?
In order to find a jeweller that gives the best rate on gold, you will need to find an honest jeweller. Study up on the price of gold first and if you have a lot of gold to exchange, you may get a better price.
Where can I find the best sources of live gold prices?
A Jelwer should give you the best price, use this when you decide to trade in your gold.
Where in a river is the best place to find gold?
The lowest point.
WHERE IS THE BEST PLACE TO FIND GOLD IN n.c.?
There is no one best place to find gold in N.C. because there are several mining locations. Among them include Guilford, Orange, Montgomery and Randolph.
How do you find IF Frequency from RF Frequency?
Transmit RF frequency subtract to the Receive frequency
What technique is used to find gold?
Back then, one of the best ways to find gold was to pan it out of the river.Panning is when you take a pan with holes and all the water drains out, but the gold stays in the pan.
