(a) On the surface of the balloon, the electric intensity is perpendicular to the surface and is constant. The electric potential varies across the surface with the highest value at the region of highest charge density.
(b) Inside the balloon, the electric intensity and potential will be zero since the Gaussian surface does not enclose any charge.
(c) Outside the balloon, the electric intensity decreases inversely with the square of the distance from the center of the balloon, while the electric potential also decreases with distance, following a similar inverse square law.
Spherical waves are produced when a disturbance originates from a point source and propagates uniformly in all directions, creating a wavefront that expands spherically. This can occur in various natural phenomena such as sound waves spreading from a sound source or light waves radiating from a point light source. The energy in spherical waves diminishes as the wavefront expands, resulting in a decrease in intensity with increasing distance from the source.
Uniformly doped refers to a material in which the dopant atoms are evenly distributed throughout the entire volume of the material. This even distribution helps in ensuring consistent electrical properties and behavior across the material.
A spherical capacitor consists of two concentric spherical shells separated by a dielectric material or vacuum. When a voltage is applied across the shells, it creates an electric field between them, storing energy in the form of electric potential energy. The capacitance of the spherical capacitor depends on the radius of the shells and the dielectric properties between them.
The state or quality of being intense; intenseness; extreme degree; as, intensity of heat, cold, mental application, passion, etc., The amount or degree of energy with which a force operates or a cause acts; effectiveness, as estimated by results produced., The magnitude of a distributed force, as pressure, stress, weight, etc., per unit of surface, or of volume, as the case may be; as, the measure of the intensity of a total stress of forty pounds which is distributed uniformly over a surface of four square inches area is ten pounds per square inch., The degree or depth of shade in a picture.
The ability to become uniformly distributed describes matter in the gaseous state. Gases have the ability to fill the container they are in completely and evenly, spreading out to fill all available space. This property is a result of the high kinetic energy and weak intermolecular forces present in gases, allowing them to move freely and disperse throughout their container.
Assuming that the charhe 'q' is uniformly distributed ina sperical volume of radius Discuss the variation of Electric intensity
A heterogeneous mixture is a mixture of two or more substances that are not uniformly distributed. The iodine and water in the question are not homogeneous because they are not uniformly distributed.
A uniformly distributed load is one which the load is spread evenly across the full length of the beam (i.e. there is equal loading per unit length of the beam).
no. the greener the part is the more it has, as a rule of thumb
Solution
When the molecules become uniformly distributed, they have reached equilibrium. This means that there is an equal concentration of molecules throughout the system, and no further net movement of molecules will occur.
Spherical waves are produced when a disturbance originates from a point source and propagates uniformly in all directions, creating a wavefront that expands spherically. This can occur in various natural phenomena such as sound waves spreading from a sound source or light waves radiating from a point light source. The energy in spherical waves diminishes as the wavefront expands, resulting in a decrease in intensity with increasing distance from the source.
loads are carried out as point load uniformly distributed load and uniformly varying load
Pigment distribution in each mycelium can vary. In some fungi, pigment may be uniformly distributed, while in others it may be concentrated in certain areas. Factors such as genetics, environmental conditions, and growth stage can influence how pigment is distributed within the mycelium.
The two categories of mixtures are heterogeneous and homogeneous. In a homogeneous mixture the components are uniformly distributed throughout the mixture. Homogeneous mixtures are solutions, such as salt water. In a heterogeneous mixture, the components are not uniformly distributed, such as granite, or Pizza.
A uniformly distributed load (UDL) is a load which is spread over a beam in such a way that each unit length is loaded to the same extent.
A homogeneous mixture is one in which the components are uniformly distributed, so that it is the same throughout. A solution is a homogeneous mixture. A heterogeneous mixture is one in which the components are easily distinguishable and are not uniformly distributed. Granite is an example of a heterogeneous mixture.