answersLogoWhite

0


Best Answer

On a riding lawn mower, the drive belt(s) goes inside the guide pins.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Does belt go inside or outside guide pins?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can I find christmas nature on Pinterest?

Pinterest has several pins that relates to Christmas nature. The Southern Living board offers 94 pins that has a royal along with a stylish feeling of a Christmas environment, both inside and outside your house.


What is a pin set that is used in volleyball?

An outside set. The antenna are also known as "pins" so "setting the pins" is a set to the outside near the antennae.


How many pins does a PCI slot have?

A 32-bit PCI slot has 62 pins. A 64-bit PCI slot has 94 pins.


You have changed the timing belt on your vectra b and the engine is miss firing?

sounds like your a tooth out on the belt , recheck the pins and marks.


How do you install a Bobcat 863 drive belt?

how do i install the timing pins on a875 bob cat skid loader to replace the timing belt


Arien's snowblower does not discharge snow?

Your belt is the first thing I would check. If your belt is ok then start checking shear pins and bolts. If they are all ok adjust your belt tightener.


Why mtd mower wont pull after changing the drive belt?

Well Hmmm... It could be the belt is to long, the tension spring is worn, if it is a vary drive system (2-belts) the vari-drive assembly may be worn and not grip the new belts. Re check your belt routing make sure it is on the inside of the guide pins and not stuck on one. If you removed the front drive pulley from the engine to remove the belt ( some people do) check to see if the drive key is still in place. One last thing is to check and see if the new drive belt is installed or seated in the transmission drive pulley, some times they can fall below the pulley.


How can you tell the difference between the top and bottom front brake guide pins on a 98 Accord?

there the same


Where was the safety pin introduced when it was first invented?

it was inside his room with he and his safety pins


How do you turn bowling pins to point the other way by only moving 3 pins?

Move the two on the outside of the line of 4 to the line of 2. Then move the single pin from the line of 1 in front of the new line of 2. Line 1: Start: 1 pin End: 0 pins Line 2: Start: 2 pins; End: 4 pins Line 3: Start: 3 pins; End: 3 pins Line 4: Start: 4 pins; End: 2 pins Line 5: Start: 0 pins; End: 1 pin.


Why did the bowling pins stop working?

if the inside of the pin is broken, called a dead pin, it does not react as much to the impact of the ball or other pins that hit it. therefore it would 'stop workin'


How do you change a belt buckle?

With some belts there are clips in the reverse side, which you can use to change the buckle. What do you do if the belt you want doesn't have clips? Well I cut the stitiching or remove the rivets, depending on which the belt has, then replace the buckle and refasten it with safety pins, or if you have a thinner belt you may prefer to staple it. Hope this helps.