answersLogoWhite

0


Best Answer

Capacitors are used to improve an inductive load's power factor towards unity. The power factor before and after adding the capacitor bank depends entirely on the inductive/capacitive values involved.

User Avatar

Wiki User

βˆ™ 12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What will be the PF if measured after capacitor bank?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What happens when lagging Power Factor changes to leading PF?

when lagging Power Factor changes to leading PF, then the voltage across the circuit in which capacitor bank is connected, is increased.


When an inductor tunes at 200 KHz with 624 pF capacitor and at 600 KHz with 60.4 pF capacitor then the self capacitance of the inductor would be?

around 10.05pf


What is the difference between 68pf and 10pf capacitor?

58 pf.


What is the use of rvt in capacitor bank?

Use of rvt in capacitor bank


A W pf capacitor is connected into a 240 V Hz circuit. what is the current flow in this circuit?

a 30 pf capacitor is connected into a 240v, 60 hz circuit. what is the current flow into the circuit


How can fluctuation in power factor be improved in single operating generator due to change in loads?

Power factor correction is normally done with a single capacitor bank. If the PF fluctuates due to a change in load, the best solution is to design and fit power factor correction capacitors at each individual reactive load that may start or stop during normal operation. Connect the PF correction directly accross the load, such that when the starter or disconnect is open, the load AND the capacitor is removed from the line, and when the disconnect is closed, both the load AND the PF capacitor is energized. Continuous loads can still be bulk-corrected with a capacitor bank, this will minimize the number of individual correction capacitors you will have to design. If properly done, your PF can be made to be very stable, with little change as the load varies.


What is the number 475 on a ceramic capacitor?

encoded capacitor value in picofarads:47, digits5, zeros following digits4700000 pF or 4.7 µF


What will be the capacitor value to improve from0.92 to 0.98 pf?

More information is needed to answer this question.


What does a capacitance meter do?

A capacitor meter measures the value of a capacitor in pf (picofarads), nf (nanofarads), uf (microfarads) or even farads. There are a million uf in a farad, 1000 nf in a uf, and 1000 pf in a nf. A farad is a very large amount of capacity. The capacity tells you how much energy the capacitor can store from a voltage source.


Why capacitor bank using reeactor?

Series reactors may be used in switching in capacitor banks. These are used to minimize the transient voltage spikes on the system resulting from switching in a capacitor bank.


How do you calculate Kwh saving after installing capacitor bank?

Adding a capacitor bank makes absolutely no difference whatsoever to the amount of energy consumed (in kilowatt hours). The capacitor bank might reduce the load current, but this does not affect the amount of energy consumed. Anyone who tries to sell you a 'capacitor bank' in order to save you energy is selling a SCAM!


What is the unit of measure of capacitor?

Capacitors are measured in Farads or microfarads.