0
That charge time is usually called the "core charge" when you get a new device the battery is dead or has been on a sleep mode. Anyway that time is to give it a corecharge, meaning more battery life in the long term.
Wiki User
∙ 13y ago
Charging a new electronic device for 8 hours helps to ensure that the battery is fully charged and calibrated. This initial long charge can help to optimize the battery's performance and longevity. It is a recommendation to follow the manufacturer's instructions for the specific device.
Add your answer:
Earn +20 pts
How do you charge a didj?
To charge a device, usually referred to as "didge," you would need to connect it to a power source using the supplied charging cable. Follow the manufacturer's instructions on how long to charge the device, typically until the battery is full. Be sure to use a compatible charger to avoid damaging the didge.
What if I Used wrong ac adapter in electronic device?
Using the wrong AC adapter could potentially damage the electronic device by providing incorrect voltage or current, leading to overheating or short-circuiting. It is important to always use the correct adapter that is specified for the device to avoid any damage. If you have used the wrong adapter, it is best to discontinue use immediately and seek a replacement adapter that is compatible with the device.
When should you use a toggle switch?
Toggle switches are commonly used when you need to easily turn a device on or off, such as lights, fans, or electronic equipment. They are simple to operate and provide a physical indication of the device's current state.
How much to run 1000 watts for 12 hours?
To calculate the cost of running a 1000-watt device for 12 hours, you need to know your electricity rate per kilowatt-hour (kWh). Multiply the device’s wattage by the hours of use, then divide by 1000 to get the total kilowatt-hours used. Finally, multiply the kilowatt-hours by your electricity rate to get the cost.
How do you calculate watts on your electricity bill?
To calculate the watts on your electricity bill, you would need to look at the wattage of each electrical device in your home (which can usually be found on the device itself or in the user manual) and the number of hours each device is used per day. Multiply the wattage by the number of hours used per day to calculate the watt-hours for each device, then sum all the watt-hours to get the total watts consumed over a billing cycle.
What are advantages of touchpad?
The advantage of a touch pad on an electronic device is that there is no need for an external keyboard. There is also no need to use a computer mouse with a touch pad device.
Does a police officer need permission to search a minors electronic device?
No I don't think so but he/she does need a reason
Where might one find Dell driver updates?
The official Dell site has all the driver updates you need for your electronic device. The drivers are free and perfectly safe to install and improve your electronic device.
Whenyou buy the ipod toch how many hours do you need to charge it?
It takes 2 hours for it to charge to 80%, and an additional 2 to charge fully.
What is the meaning of electronic distance meter?
an Electronic Distance Meter (EDM) is a device that uses infra red or lasers to measure distance, removing the need for tape etc
How long would it take to charge a car battery with a 6 volt motor?
The car battery has 12 volts; you need MORE than that to charge it. You can't charge it with 6 volts, unless you somehow raise the voltage. In that case, how long it takes to charge the car battery will depend on the capacity of the charging device. Usually a few hours.
Not all electronic devices are computer, discuss In details?
First you need to able to distinguish between electronic device and and computerize device. Electronic devices are device that needs power source (electricity) for operation. While a computer is an electronic device that accept data, process data and give an output base on the received input. Not all electronic devices are computer with the below key points. A computer have input unit, processing and output unit which other electronic devices do not have this features. A computer must be able to accept instructions, eg your mobile phones, calculators can accept instructions so they are computer because they have an input method. While an electronic device does not have any input method like your radio. You radio only need a power source to transmit sounds via electromagnetic waves, it doesn't have input, output nor processing unit
How many hours do you need to charge your ipod touch everytime?
About an hour.
Where can I find a charging pad for my rechargeable wireless device?
You can find a charging pad for your rechargeable wireless device at more electronic store or online at amazon, overstock or wireless4less.com. You will need the product number for your wireless device.
Can anyone indentify this electronic device?
You definitely need to provide more details. For example, a diagram or photograph might help.
What are the three things electronic hardware devices need in order to function?
An electrical system to provide power It needs software to instruct the device A method for the CPU to communicate with the device
How long is the 3DS charge?
The 3DS takes 3 1/2 hours to charge. The battery will then last around 3-5 hours of gameplay (depending on your settings) before you need to charge it again.
