0
Where on the cylinder walls does the greatest amount of wear occur?
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How can an operator repair pinhole leaks in the walls of a chlorine cylinder?
I suppose that the recommended solution is to send this cylinder to metal scrap.
What is the affect on the pressure inside a cylinder when a plunger is pushed in?
Pushing the plunger into a cylinder decreases the volume of the cylinder, which increases the pressure inside. This is due to the gas molecules being confined to a smaller space, resulting in more frequent collisions with the cylinder walls, hence higher pressure.
Plant cell walls contain a large amount of what carbohydrate?
carbohydrates
Why does the the meniscus in a graduated cylinder filled with water curve downward?
The meniscus in a graduated cylinder curves downward due to adhesive forces between the water molecules and the glass surface of the cylinder. This causes the water molecules at the edge of the liquid to be attracted to the glass and form a concave meniscus shape.
Why do reverberations occur?
The reflection of sound waves off of walls, floor, ceiling, seats, and people causes reverberation.
Why does a loss of lube oil occur?
Some lubricant is lost in the combustion chamber as it used to reduce friction between the piston oil rings and the engine's cylinder walls .
What is the maximum amount of walls you can have in Clash of Clans?
The maximum amount of walls you can have in Clash of Clans go up to Level 10
Is the greatest and walls come down an album by Keke Palmer?
"The Greatest" and "Walls Come Down" are not albums by Keke Palmer. They are singles featured on Keke's album, Awaken Reloaded.
Why is graphite used in motor oil?
To fill the scratches on the cylinder walls
How do you deglaze a cylinder?
Get honing stones and install on a drill. Use a lubricant such as WD-40 or Pb blaster to spray cylinder walls. Run honing stones up and down inside cylinder while operating drill. This will create a cross-hatched pattern on cylinder walls, just clean residue away and your done. Repeat for each cylinder.
How can an operator repair pinhole leaks in the walls of a chlorine cylinder?
I suppose that the recommended solution is to send this cylinder to metal scrap.
Where does gas exchange occur?
gas exchange occurs between the thin walls of the alveoli and the thin walls of the capillaries
How do moving molecules cause pressure inside a cylinder of butane?
Moving molecules in a cylinder of butane collide with the walls of the cylinder, creating a force per unit area known as pressure. The more molecules and the faster they are moving, the higher the pressure inside the cylinder.
If oil is empty in your car will it steam?
It will smoke and eventually seize the pistons. Without oil between the pistons and the cylinder walls, you'll have metal-on-metal contact, and this will effectively weld the piston heads to the cylinder walls. Then you're going nowhere.
How is a cylinder and a prism alike and different?
Alike: Both Cylinder and Prism have the same corresponding Top and Bottom. This is the definition. A Cylinder can be considered as a prism with infinite no. of sides. Different: The side walls of any Prism are flat but that of a cylinder is curved.
Why does a concave meniscus form when water is in a graduated cylinder?
A concave meniscus forms in a graduated cylinder with water due to adhesive forces between the water molecules and the walls of the cylinder. This causes the water to cling to the walls, resulting in a concave shape.
Why does the the meniscus in a graduated cylinder filled with water curve downward?
The meniscus in a graduated cylinder curves downward due to adhesive forces between the water molecules and the glass surface of the cylinder. This causes the water molecules at the edge of the liquid to be attracted to the glass and form a concave meniscus shape.
