Saturated = 366 Deg F
It takes a certain energy to convert water to steam. Any additional energy you supply to the water, as heat, will be taken away by water converting to steam. The maximum temperature of a liquid is its boiling point so water shows constant maximum temperature 100o Celsius (if it is pure).
To calculate the conversion of steam to condensate, you can use the formula: Steam Converted to Condensate = Steam Inlet - Steam Outlet This formula subtracts the amount of steam leaving the system (Steam Outlet) from the amount of steam entering the system (Steam Inlet) to determine the amount of steam that has been converted to condensate.
Water has a boiling point of 100 degrees Celsius. When water reaches this point it becomes a gas (steam). Therefore you can say that the average temperature of steam is around 100 degrees Celsius.Answer:Steam is not the white plume from the spout of a kettle, but the hot uncondensed water vapour before this condensation takes place. It has a temperature equal to the liquid it comes from. This is not limited to 100oC except in systems that are open to the standard atmospheric pressure of 760 mm Hg.In high pressure industrial borders steam temperatures can be several hundred degrees centigrade at several atmospheres pressure. Conversely at extreme elevations water boils far below 100oC and the steam is correspondingly cooler.
Uranus's lowest temp can get down to -355.
gland steam temp should be nearer to less than turbine lub. oil flash point.
The temperature of 70 psi steam is approximately 318°F.
50-60psi key on engine off, 45-60psi key on engine running
Saturated = 366 Deg F
171 deg C
Steam Boilers don't usually cut out on temperature but when they reach a preset pressure.
it is steam sterlization in which temp & pressure both works
60psi
about 60psi
Depends on size of pipe
50 to 60psi
calorifier contains the number of coils through which steam flows. Steam from steam boiler goes to kitchen,laundry and for calorifier.Around these steam coils,water is flowing which needs to be heated. as u know temp of steam would be more than 100 deg,it heats the water which comes in contact with these coils . in most of the calorifiers,a set point mechanism is fitted which cuts the flow of steam whenrequired temp of water has attained