There are many configurations of plugs and receptacles. The reason for these different configurations is to prevent higher rated amperage devices being inserted into smaller size supplies. In North America there is a NEMA configuration standard that designate the different amperage's and voltages that are allowed to be used for specific purposes. A web search will bring up two specific charts for straight blade devices and twist lock devices.
A slotted spoon is typically used to separate solids from liquids. When using a slotted spoon, the liquid drains through the slots while the solids are retained in the spoon, allowing you to easily separate out and remove the desired components from the mixture.
You can use a slotted spoon to lift food out of liquid. The slots allow the liquid to drain away while keeping the solid food on the spoon.
No, you cannot use a metrc socket on a standard socket wrench. These are two different systems of measurement and are not interchangeable.
A 36mm socket is equivalent to approximately a 1-7/16 inch socket in the Imperial measurement system.
The shoulder socket is deeper than the hip socket because the shoulder joint sacrifices stability for mobility. This design allows for a greater range of motion at the expense of stability. In contrast, the hip joint is designed for weight-bearing and stability, so it has a shallower socket to provide better support for the body.
It requires a special slotted socket. It will be cheaper to have a repair shop do it for you.
by unplugging the sensor from the contact and using a slotted socket to remove it. This socket usually is bought separate from a set.
It will require a special slotted socket that can only be used for the one purpose. The cost does not justify the means.
A machine screw typically has a slotted or Phillips drive whereas a cap screw typically has a socket or torx head.
the slotted plug is removed when you need to turn the crank over by hand, such as to adjust valves,or to perform leak down test. You would find a nut inside as to use a socket on,for rotating the crankshaft
It requires a special socket that is slotted up one side so as not to damage the wiring. The cost of the socket is quite high and will not justify the purchase unless you plan on using it often.
You have to purchase a special socket that has a slot in it to remove the o2 sensors. There are four of them two up stream and two down stream. the up stream ones are under the hood as soon as the exhaust comes out of engine. Just unplug and use slotted socket to remove and replace sensors. the down stream ones are under the car before the Y section of the exhaust pipe ends you remove and replace same as the up stream ones. You can purchase the slotted socket at any auto parts store same as the sensors. The sensors are about $65.00 each socket about $8.00 dollars.
Turning slotted head screws.
This is a screw with head 6-point star-shaped pattern (in the same way that slotted heads, Phillips, hex socket, and Robertson have linear, cruciform, hexagonal, and square tips, respectively).
The word slotted is a verb. It is the past tense of the verb slot.
the use of the slotted weight is to throw it like a ninja star at your friends!
It will be cheaper for you to have a repair shop do it for you as the socket required cost around $90.00 and can Only be used for that 1 purpose. It is slotted down the side so the wiring harness is not damaged.