White is commonly used as the neutral wire in electrical wiring, not the ground wire. The ground wire is typically green or bare copper. It's important to follow proper safety guidelines and consult a professional when working with electrical wiring.
The red wire is typically used as the hot wire in a standard 120-volt electrical system, while the black wire is used as the hot wire in a 240-volt system. Common wires are usually white or gray.
You can hot wire a boat. It just matters what type it is.
In electrical wiring, the live or "hot" wire is typically brown or red, the neutral wire is typically blue or black, and the ground wire is yellow or green. So, in this case, the brown wire is likely the hot wire, the blue wire is the neutral wire, and the yellow green wire is the ground wire.
You have a 3 way switch. Your black wire is the hot wire. Your green wire is the ground wire. Your red and white wires go to the light and other switch. You should have gotten a wiring diagram with your switch.
You hook them in parallel pos to pos and neg to neg.
in parallel pos to pos neg to neg might want to use an isolator
missing groung wire.
I believe it causes full power of battery flow to the neg. Where used photons of energy should be. Perhaps it gets hot enough then leaks?
red to pos black to neg
check the ground wire stemy. from the batter neg to the neg on the head light neg side
Bad groung and or bad sending unit.
the battery will have a - mark on it which means neg., and the cable that is bolted to the engine block is the neg. cable, the pos. cable will go to the starter.
take the batt constant, and the acc. and connect them to the pos clip, and the neg. wire to the neg. clip
hot wire on the timing light goes to pos. side of the battery and the neg. side of timing light goes to ground on the engine someplace and then the plug clip goes on the #1 spark plug wire.
White is commonly used as the neutral wire in electrical wiring, not the ground wire. The ground wire is typically green or bare copper. It's important to follow proper safety guidelines and consult a professional when working with electrical wiring.
TRy on the neg side of the coil.