A pool pump motor which is drawing half the amps listed on its nameplate can indicate a problem with the windings or a lack of incoming current. Pumps will only draw as many amps as are required to operate under the current load.
An LED typically consumes around 20mA (0.02 amps) of current to operate. Exceeding this current limit can damage the LED.
To determine the amperage required by a 12-volt audio radio, you would need to know the power consumption of the radio in watts. You can then use the formula: Amps = Watts / Volts to calculate the amperage.
The amount of amps required to start an engine varies depending on the size and type of the engine. As a general guide, small engines may require around 50-100 amps to start, while larger engines like those in trucks or heavy equipment may require several hundred amps. It's best to refer to the specific manufacturer's recommendations for the engine in question.
The amperage required to run a computer and monitor can vary depending on their power consumption. A typical desktop computer consumes around 3-6 amps, while a monitor can use around 1-2 amps. It's important to check the specifications of your specific devices to determine the exact amperage they require.
amps equals watts divided by volts.
A 15 amp circut will be fine.
A pool pump motor which is drawing half the amps listed on its nameplate can indicate a problem with the windings or a lack of incoming current. Pumps will only draw as many amps as are required to operate under the current load.
1100 watts or about ten amps then another 3 to 4 amps for turn table light and fan
A 120 volt table lamp with a 75 watt bulb will pull 0.625 amps. With a 100 watt bulb it will pull 0.833 amps. And with a modern fluorescent 13 watt bulb it will pull 0.108 amps.
300 Amps if used for service entrance conductors. Table 310.15
An LED typically consumes around 20mA (0.02 amps) of current to operate. Exceeding this current limit can damage the LED.
Grange insurance is an insurance company and is not specifically required to operate a boat. Boating insurance is however required in many areas. Check with your local laws on insurance requirements.
The formula is volts times amps equals watts, or watts divided by volts equals amps.
To determine the amperage required by a 12-volt audio radio, you would need to know the power consumption of the radio in watts. You can then use the formula: Amps = Watts / Volts to calculate the amperage.
As a continuous load your TVs have to add up to 12 amps or less. There will be a rating plate on TV. At about 3 amps per TV would allow 4.
There are actually three pieces to this puzzle - resistance. And you're missing that one.