Go to the auto parts store and purchase a puller, for that type of fuse.
Wiki User
∙ 15y agoTo pull a Type B fuse, first switch off the main power supply. Use a fuse puller tool or a pair of insulated pliers to grip the fuse firmly and gently pull it out of the fuse socket. Be sure to replace the fuse with the correct amp rating to avoid electrical issues.
A person with type B blood can receive blood from donors with type B or type O blood. This is because type B individuals have B antigens on their red blood cells and anti-A antibodies in their plasma. Type O blood is considered the universal donor for individuals with type B blood.
No. The child will be type B or O, it cannot be type A.
Possible blood types are A, B, or AB. Basically, the offspring can be any blood type except for O.
A - blood type
A person with B type blood can donate to a patient with B type blood and to the universal receiver. The universal receiver is type AB+. A person who does not carry the Rh factor, which means they are either B negative, AB negative or O negative, cannot receive B positive or AB positive blood.
a g type
check either end of the dash when you open the doors the fuse panel doors are the pull type
Pull the ECM fuse or the injector fuse , or you can pull the fuel pump relay out of it .... all will keep it from starting
buy a new fuse. under the hood there is a relay fuse box. check your book to see what fuse to pull. pull the said fuse and relpace it with the new fuse.
hi there, your fuse you are looking for is located behind the glove box on the passenger side of the van. once you've taken out the glove box, you will see the fuse board. pull the cover off then you will see X2 clips on the fuse board, pull them down and there is ANOTHER fuse board behind the first fuse board. im not sure what fuse it is but i know it's a 7.5 AMP so you will have to check them all. many thanks and good luck. Baz B.
eassy pull the fuse box cover off turn it over located the tail light fuse pull it out replace with same amp fuse
Pull the ABS fuse located in the under hood fuse box. Pull the ABS fuse located in the under hood fuse box.
the 73 used cylinder type fuses, locate the fuse panel, check fuses for continuity, pry out one edge of the bad fuse and pull the other side out. To install, place new fuse in holder and snap in place
First locate the fuse in the fuse box, then pull old fuse out and insert new fuse.
Where is the fuse panel that contains the radio fuse?
: you get the plug and in sted of push srew then pull when you reach the fuse slowy pull apart the rest of the lighter then and when all that is left is the oil and the fuse take the fuse out carfully.
Assuming the fuse is the type that is pressed into it's contacts, and assuming the fuse is de-energized when the disconnect is open (off), I usually place a screw driver behind the fuse on one end or the other, pull it out until I can get hold of it, and pull it out completely. As a matter of standard practice you want to wear leather gloves and treat it like it is hot (energized) until it is removed. If it is big enough you can simplify this procedure by just grabbing the fuse with one hand and pull. It should be extremely tight so be careful not to throw the fuse or your hand into something else that is energized.