0
To machine a square cross section on a lathe, you would use a parting tool to remove excess material around the perimeter of the square, leaving the desired square shape. You would then use a square nose turning tool to further refine the shape and achieve the exact dimensions. It's important to make precise measurements and take light cuts to avoid removing too much material at once.
Add your answer:
Earn +20 pts
Can granite or marble be turned on a lathe?
Yes.
I have a coolant motor with 420 volts in Lathe Machine but the supply voltage will be 480 volts. Can 420 volts 50Hz coolant motor can use in 480 volts 60Hz?
No, it is not recommended to use a 420-volt motor rated for 50Hz in a 480-volt system with 60Hz frequency. The motor may not be designed to handle the higher voltage and frequency, which could result in overheating or damage to the motor. It is best to use a motor that is rated for the specific voltage and frequency of the system.
How do you build a single action revolver from scratch?
You would need a metal working lathe, the correct steel for the frame, cylinder and barrel, steel of a different type for the springs, hammer and firing pin. A good set of plans would help, along with the ability to use machine tools. You would need to build a rifling cutter to rifle the barrel after you bored the barrel. Should not cost you more than $3-5,000 to build one from scratch.
What are good machining metals?
Some good metals for machining include aluminum, brass, copper, stainless steel, and titanium. These metals are known for their machinability and can be shaped and formed accurately with various machining processes.
What are the example of turning tools?
Examples of turning tools include woodturning tools such as gouges, chisels, and scrapers used in woodturning to shape and cut wood on a lathe. In metalworking, turning tools can include carbide inserts, tool bits, and boring bars used on lathes to cut and shape metal workpieces.
How do you use a lathe?
To do this you must train. lathe is used for parts. The final product is always a circular cross section.
What tool is a square?
tool post is used to handle the tool on the lathe machine
What is a square tool post?
tool post is used to handle the tool on the lathe machine
What is feed in lathe in machine?
non- examples of feed in lathe machine?
What is difference between turning machine and lathe machine?
There is no difference between a turning machine and a lathe. They are two names for the same kind of machine
What are the short comings of lathe machines?
what is lathe machine in short answer
What is difference between lathe machine and drilling machine?
difference between lathe and drill machine doing full on piece of metal
What is the difference between lathe machine and drilling machine?
difference between lathe and drill machine doing full on piece of metal
Give the type of lathe machine?
Lathe specifications· Distance between centers· Swing over the bed· Swing over the cross slide· Horse power of the motor· Number of speeds
What is profiling on lathe machine?
Vertical milling machine is for cutting large pieces. The lathe cutting tool motion is perpendicular to the ground. They are said to Karosl lathe.
What is imagination lathe?
lathe machine, power depends on the size and power of electric motor and gearbox lathe.
Who is father of lathe machine?
The lathe machine is an ancient tool, dating back to approximately 1300 BC. It was first developed as a two-person lathe by the Ancient Egyptians.
