for USA, Canada and countries running a 60 Hz supply service.
A new 240 volt socket outlet needs to be installed so that you can then just plug the new dryer into it.
Call a licensed electrician.
Here are more answers from WikiAnswers contributors:
Lowe's.com has a very good tutorial on how to wire 240 volt receptacles including the hookups in the fuse box.
<><><>
As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.
Before you do any work yourself,
on electrical circuits, equipment or appliances,
always use a test meter to ensure the circuit is, in fact, de-energized.
IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.
You'll have to change the wiring and the receptacle. Your oven is most likely 4-wire, and your dryer circuit is 3-wire. Even if your oven is 3-wire, it will need more amperage than the dryer. Ovens typically require 30-40 amps, which will require a circuit (wire and breaker) rated for 40-50 amps. The range plug is designed to go into a 240v, 50a receptacle, so I would make my new circuit 50 amps, with 8/3 (with ground) romex. <><><> As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed. Before you do any work yourself,
on electrical circuits, equipment or appliances,
always use a test meter to ensure the circuit is, in fact, de-energized.
IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.
As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.
Before you do any work yourself
on electrical circuits, equipment or appliances,
always use a test meter to ensure the circuit is, in fact, de-energized.
IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.
Buy the appropriate dryer outlet. Loads are black and red, neutral is white, gnd is green or bare stranded. Many receptacles will have marks to identify the wires, use the marks to match up and guide you on which wire to put where in the new receptacle. Be sure to turn off the breaker or remove the fuse to the outlet before you begin.
Yes, you can. Don't forget to also convert the stove BREAKER to a dryer BREAKER (otherwise your dryer can someday fry well before the breaker trips).
No, a dryer cannot cause a phase change. A dryer operates by using heat and airflow to evaporate moisture from clothing, but it does not have the ability to induce a phase change such as solid to liquid or liquid to gas.
No, you should not change a dryer plug to fit a regular wall plug because they have different voltage and current requirements. It's important to use the correct plug and outlet for each appliance to prevent damage or safety hazards. It's best to consult with a professional electrician for proper installation.
Yes, there are two common types of 4-prong dryer plugs: NEMA 14-30 and NEMA 14-50. The NEMA 14-30 plug is used for dryers that require 240 volts and 30 amps, while the NEMA 14-50 plug is used for dryers that require 240 volts and 50 amps. It is important to use the correct plug type for your specific dryer.
You will need to replace the 3-prong outlet with a 4-prong outlet to match your dryer cord. Alternatively, you can replace the cord on your dryer with a 3-prong cord that matches the existing outlet. Make sure to consult a professional if you are not comfortable with electrical work.
To change the spark plugs on a 2002 Volvo S40, you will first need to locate the spark plugs, usually found under the engine cover. Remove the engine cover and then use a spark plug socket and ratchet to unscrew and remove the old spark plugs. Finally, install the new spark plugs, making sure they are properly tightened.
The plugs are different. The prongs are straight on one and angled on the other. The wire and breaker are the same. You can either change the outlet or the cord.
No, you should not change a dryer plug to fit a regular wall plug because they have different voltage and current requirements. It's important to use the correct plug and outlet for each appliance to prevent damage or safety hazards. It's best to consult with a professional electrician for proper installation.
when do you change spark plugs
get a schematic free for whirlpool gas dryer
To change the spark plugs in a 1997 astro van do I have to change the spark plugs from the bottom of the engine/
Generally I change platinum plugs at 100K and regular plugs at 50K.
No, a dryer cannot cause a phase change. A dryer operates by using heat and airflow to evaporate moisture from clothing, but it does not have the ability to induce a phase change such as solid to liquid or liquid to gas.
how to change spark plugs on a 2001 expedition
how do you change spark plugs on 1995 Lexus es300
How do you change spark plugs on a 2001 suzuki vitata xl7
how do i change the spark plugs on a Chevy silverado 1500
1999 Volkswagen Beetle how to change spark plugs