answersLogoWhite

0

To adjust the flame on an Efel oil stove, locate the flame control knob, usually situated on the front or side of the unit. Turn the knob clockwise to increase the flame and counterclockwise to decrease it. Make small adjustments and allow the stove to stabilize before making further changes. Always ensure proper ventilation when operating the stove for safety.

User Avatar

AnswerBot

8mo ago

What else can I help you with?

Related Questions

What is the name of a wood oil stove used in Nova Scotia?

Efel


How do you start a Efel oil burning stove?

..you make sure you have an UPDRAFT..by opening the door an inch and opening a window in the room a crack...then I trigger a butane lighter and stick the flame inside to make sure the flame is being drawn toward the chimney. If you do not establish an updraft...you can fill the room with smelly oil smoke within seconds of lighting the stove. You'll only do this ONCE..! ..With a good updraft..I turn the knob to between 1 and 2 and push the electric lighter button , WITH THE DOOR OPENED ABOUT A HALF INCH, and within a few seconds the oil ignites. ..I let it go this way for about three minutes....you are heating up the "catalizer" and the flame will now be mostly a yellow colour. (Close the window) ..after a few minutes you can close and lock the door and the yellow flame will turn blue and circle the catalizer which is gradually turning red. Mine is ten years old and I'm very satisfied with it. Bill


What will chocolate melt faster in oil or water?

Oil, try it out on a stove.


Why don't you put water on an oil flame?

Oil is less dense than water, so if you throw water on an oil flame the oil will float on top and continue to burn.


Why do not put water on an oil flame?

oil gets on top of water and oil is flamable


Why a peanut keeps a flame?

oil burns, peanuts are 50% oil


How does a peanut maintain a flame?

It has a lot of oil in it.


What is technology of oil fired furnace?

An oil fired furnace works by using oil and a flame. The oil is sent through a tube to the burner area of the furnace and when the oil is ignited with a lighter, the flame can be adjusted according to how much heat is necessary.


How do you use citronella oil?

You fill the torch area with the liquid and have to have a soaken wick, in there, too. You light it and adjust the flame. Always have water available in case of mishap.


How do you use a super flame oil heater?

super flame oil heater is quite simple to operate. First open the cover and make sure the internal burning area is free from debris..on the right hand side towards the top is a knob that will allow the flow of fuel oil into the burning area. Turn this valve to medium.....use a paper towel and wad it up, lite it and place into the burning area....(you should see a wet spot before placing burning paper towel)...close the door and it will take a few minutes for the burning area to fully get going and give off a full burn. Make sure you have the correct stove pipe if going through the roof ..or wall...as this stove gives off intense heat and any pipe touching any wood or anything would eventually catch on fire.I put a metal pipe thru the wall then inserted a the stove pipe thru it as to insulate the stove pipe inside a tunnel away from wood or insulation. Adjust the heat setting per size of area your heating, which if a small area it'll run and heat very well on just above low or between med and low


How do you make a pan flame when cooking with olive oil?

Usually alcohol is used to make flame, or " Flambé"


What makes the flame in a flame thrower?

A mixture of fuel (propane/oil) and heat. They can have a miniature lighter at the nozzle too