answersLogoWhite

0


Best Answer

1-3-4-2.......2.3 L engine. Check where the rotor points when the engine is at compression stroke on the number 1, take out spark plug on first cly. and turn by hand. You will find it. when piston is at the top, look where the rotor points. Goog luck.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar
More answers
User Avatar

AnswerBot

7mo ago

The firing order for a 1992 Mercury Topaz with a distributor cap is 1-3-4-2. This means that the spark plugs should be connected to the distributor cap following this sequence to ensure proper ignition timing. Make sure to double-check your specific engine model for accuracy.

This answer is:
User Avatar

User Avatar

Wiki User

13y ago

2.3L engine. If the dist. has not been moved. Looking at the engine from the front of the car, the number 1 position for the Ign. wire should be about the 11:00 0' clock position. Then turning clock wise the next one is for the number 3 cyl. then for the number 4 cyl. then the number 2. that's 1,3,4,2. The cyl. numbers from the front and your left side are 1, 2, 3, 4. If all has failed, then remove the number 1 spark plug, turn the engine over by the belt and with your finger in the spark plug hole you will feel the air push up at the T.D.C. position. When the piston is at the very top, look where the rotor is pointing ( with the cap off ) and that's where you plug in the number 1 spark plug wire. Good luck.

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Firing order on distributor cap 92 Mercury Topaz?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Natural Sciences

What is the firing order for a 1994 Mercury Topaz?

The firing order for a 1994 Mercury Topaz equipped with a 2.3L engine is 1-3-4-2.


Which direction does the distributor rotate on a 1987 Ford Ranger 2.9L?

The distributor in a 1987 Ford Ranger 2.9L engine rotates clockwise. This rotation direction is when viewing the engine from the front of the vehicle.


Replace distrutor cap on 1992 mercury topza?

To replace the distributor cap on a 1992 Mercury Topaz, locate the distributor on the engine. Remove the screws or clips securing the cap in place, then carefully lift off the old cap. Place the new cap in the same position, securing it with screws or clips. Be sure to connect the spark plug wires in the correct order onto the new cap.


How do you disable the governor or rev limiter on a 1994 Mercury Topaz 4-cylinder?

You would need to reprogram or replace the Engine Control Module (ECM) in order to disable the governor or rev limiter on a 1994 Mercury Topaz. This is a complicated process and may require professional assistance to ensure it is done correctly and safely. Keep in mind that removing these safety features can potentially damage the engine.


How do you install an alternator on a 1993 mercury topaz?

To install an alternator on a 1993 Mercury Topaz, first disconnect the battery and locate the alternator. Remove the drive belt, unplug the electrical connections, and remove the mounting bolts. Install the new alternator in the reverse order, making sure all connections are secure before reconnecting the battery.