On metric gauge 2.5 to 3 bar, about 40 to 45 psi. At least 15 psi, 25 psi would be better, 40 psi on a good engine.
Should be at least 10 at idle. 25 at idle would be better.
same prob w mine, burned wires, almost toated jeep. dont do it. bring to mechanic. worth 75 bucks. 25 for relay, 50 labor
autozone.com will let you look at it but not download it As I stated earlier, free manuals for cars are pretty non existent. Haynes Manuals ,available at AutoZone and NAPA stores are only about $25
is the sound speed dependent.do you hear it start and go away at certain speeds say its there from 25-45 mph?if it is a high pitched rotational noise it is either the brakes are worn and squealing or the front hub or hubs are making the noise.this is fairly common.the inner seal of the hub gets worn and dry and makes the squeak.hub needs replacement not serviceable
2.5 liter Petrol 8-1 diesel 25-1 compression
The compression ratio of a Diesel ranges from 14:1 to as high as 25:1. I agree just depends on engine.
between 18 and 25 to one depending on engine I agree. It all depends on what engine you have.
0-25
presume diesel engine 25 foot pounds
It'll probably be OK. As long as there's enough diesel to properly lubricate the injection pump then no problems.
No, it is not recommended to put rubbing alcohol in a diesel engine. Rubbing alcohol is not formulated for use as a fuel additive and can cause damage to the engine. It's best to use diesel fuel additives that are specifically designed for diesel engines.
if it is diesel engine 25 foot pounds
Petrol & Gas engines are spark ignited engines where as diesel engines are compression ignited engines. Petrol engines works with explosion of fuel air mixture due to spark from spark plug inside the cylinder. Diesel engines works with combustion of fuel air mixture due to compression, compressed mixture attains a very high temperature which exceeds the flash point of diesel and starts burning inside the cylinder and the hot gases after burning of fuel misture exerts force on piston which makes the diesel engines work. Diesel engines are highly efficient than petrol engines.
The consumption of lubricating oil for a diesel engine depends on the operating conditions and the design of the engine. There are some averages depending on the year of the engine. Pre 1980's engine are around 25% of fuel consumption. Pre 1990 engines are around 20% of fuel consumption and more recently built diesel engines are around 1% of fuel consumption.
the fuel capacity for jeep grand wagoneer in the 80s is between 22 gallons and 25 gallons depending on the engine size
25