answersLogoWhite

0


Best Answer

If you mean the hole cut into the skin, it is called the port hole and it is used to mic the bass drum.

If you mean the groove cut into the inside diameter of the hoop, it is used for attaching the kick pedal.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is an inlay cut on a bass drum hoop?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Music & Radio

Why cut a hole in a bass drum?

It allows for greater projection of sound and alters the tone of the drum. It is also used for recording or when micing a drum for live performance: it is easier for a microphone to capture the sound of the drum when it is inside or directly in front of the hole. http://www.wikihow.com/Port-a-Hole-in-a-Bass-Drum


Difference between flatbed and drum plotter?

The main difference between flatbed and drum plotters is that the drawing surface is wrapped arround the perimeter of a drum. The drum plotters are generally smaller than flatbed plotters. The drum plotters have lower resolutions than flatbed. flatbed plotter can cut more thick material, can can finish cut at one time, do not need to leave a little at the edage.


How do you make a 45 gallon drum burner?

for trash ? put holes 1 inch up from bottom, in drum, at least 1inch in dia, all around drum, sit drum up on cement blocks, cut top out, drop a few bricks in bottom lay an old grill grate on bricks, [allows air flow]


What is a bearing edge on drum shell?

It is the surface of the drum shell that actually touches the drum head. The area of this surface is less than that of a cross-section of the whole shell, since it is created by making an angled cut into the shell around the rim. The thickness or thinness of the bearing edge affects the tone of the drum; finer or sharper bearing edges yield a brighter tone, while thicker bearing edges yield a warmer tone. If the bearing edge is not perfectly level and perpendicular to the cylinder of the shell, the drum head will not seat properly and the tone of the drum will suffer.


Is there a amplifier that plays both bass and guitar?

Actually, you can play both bass and guitar on any amplifier. But to produce a better and lower sound for bass, you need a special amplifier for it. I am not sure that there is an amplifier that can play bass and guitar with equal quality.

Related questions

Why do your legs go numb when you wear your marching band bass drum?

you cut off the blood supply to your legs- position the drum just a bit differently!


What is side-chain in audio recording?

Sidechaining is where you have two signal, A and B and the signal B affects how signal A is processed. For example if you have a kick drum and bass track, if you put a compressor on the bass track and send the kick drum to the side-chain of that compressor, the compressor will act by how the kick drum plays, and thus gives more room for the kick to cut thru the mix as the bass ducks when the kick drum hits.


Why cut a hole in a bass drum?

It allows for greater projection of sound and alters the tone of the drum. It is also used for recording or when micing a drum for live performance: it is easier for a microphone to capture the sound of the drum when it is inside or directly in front of the hole. http://www.wikihow.com/Port-a-Hole-in-a-Bass-Drum


What was the original basketball hoop made of?

An apple basket with the bottom cut out.


Why the series motor starter is called drum controller?

It is in form of a drum . As the drum is rotated, series resistance is gadually cut off.


What nicknames does Ogden Bass go by?

Ogden Bass goes by Mr. Line Cut, and OB1.


What is the climax in the story The Bass the River and Sheila Mant?

The Narrator chooses to cut loose the bass.


Are the 14k Gold Diamond-Cut Hoop Earrings suitable for a teenager?

Yes they are cute and her friends will like them.


How can you make an umbrella?

materials: waterproof ripstop nylon, extra large petticoat hoop, medium size petticoat hoop, 1" dowel, three feet long, 1 carpet tack cut the nylon into a circle bigger than the extra large hoop sew the nylon to the hoop sew the medium hoop to the center of the circle carpet tack the end of the dowel to the center of the umbrella.


Difference between flatbed and drum plotter?

The main difference between flatbed and drum plotters is that the drawing surface is wrapped arround the perimeter of a drum. The drum plotters are generally smaller than flatbed plotters. The drum plotters have lower resolutions than flatbed. flatbed plotter can cut more thick material, can can finish cut at one time, do not need to leave a little at the edage.


Is a ruptured ear drum a disease?

No, it is a physical problem, like getting cut.


What is the name of the fish that was cut in half by God and thrown to the dead sea?

bass