If they aren't severe, try Meguiar's Plastic Glaze.
The fuse in under the hood. In the engine fuse compartment. It is a mini 10a fuse. It is located above the engine control module in a kinda fuse holder thinggy... (yellow holds two fuses, pull up on it and twist the fuse to remove) the radio is on the left or toward the front of the vehicle
You do not need to remove wiper arms to replace the filter. Pull the rubber cowl weatherstrip outward to remove on the passenger side about halfway across toward the drive side. Remove the cowl grilled cover, it has plastic fasteners that does not need tools to remove. Start be pulling the end of the panel gently upward enough to pop the plastic fasteners up so you can remove them by hand. Be careful when pulling on the plastic fasteners as they could be very sharp on the edges. There will be an old plastic air inlet cover under that cowl grilled cover. You can either remove the plastic fasteners like above or you can cut the plastic rosebud fasteners. Clean the area and you are ready to install the new filter.
On my 1993 MPV it is like this. Remove the ash tray. Remove the 2 screws holding the plastic frame, now visible on the bottom of the ash tray holder. Unsnap the frame from the bottom. Unscrew the cigarette lighter bulb holder and unplug the cigarette lighter connector to get them out of the way. There are 5 screws. 1 in each corner and one in the bottom center. Unscrew them and pull the radio out just far enough to see the plastic molex connectors. There are 2 plug connectors and the antenna wire connector. Unplug them and plug into new radio. Put it back together.
All the 99/04 WJ Jeep Grand Cherokees come with the cabin filter housing, but the filter was not a standard item. It had to be purchased as an after market accessory. You do not need to remove wiper arms to install the filter. Pull the rubber cowl weatherstripping outward. Remove the weatherstripping on the passenger side about halfway across toward the driver side. Remove the cowl grilled cover, it has plastic fasteners that does not need tools to remove. Start be pulling the end of the panel gently upward enough to pop the plastic fasteners up so you can remove them by hand. Be careful when pulling on the plastic fasteners as they could be very sharp on the edges. There will be an old plastic air inlet cover under that cowl grilled cover. You can either remove the plastic fasteners like above or you can cut the plastic rosebud fasteners. Clean the area and you are ready to install the new filter.
Unbolt it.
plastic explosives,just kidding.its behind the timing belt,serious pain in the ass
you dont its just for show evidently
you have to go inside engine compartment to the front right side,then reach in and disconnect signal/parking bulb holder electrical connector.Then rotate the turn signal bulb holder 1/4 turn COUNTERCLOCKWISE to remove it.
use the remove timing belt instructions and it includes the water pump,"if your in there do them all !"
Get under the car and remove any bolts holding it together. Also check inside the drunk for bolts.
under the passenger dash. You have to remove the glove box and lower trim to get to it.
Safely jack the car up, remove lamps,replace bulbs.
Its below the air unit , remove filter air unit and ooops ther it is.
use brake fluid
You open the trunk and remove the plastic wingnut screw on the backside of the tail light and replace the bulb and put the nut back on...very easily done without tools...
The 2002 Mitsubishi Gallant computer is located behind the passenger side dashboard. You will need to remove the glovebox in order to access the computer.