i dont know oem is original equipment manufacturer that means a factory installed radio
Removing the radio from a 1990 Cressida is a pain, mainly because it is in three parts (radio/CD player, radio/CD player controls, and amplifier). First you remove the trim from the transmission shift area, then begin removing all the plastic items from around the radio and control strip, working your way up from the shift area. Note that you will probably not be able to replace the OEM radio --Toyota wants $2300 for one, but they don't have any. If you install an after-market replacement radio you'll have to rewire the speakers, because they are connected to the separate amplifier, located behind the radio on the firewall, which can only be controlled by the OEM system. Note also that if you install an after-market radio and you bypass the OEM radio controls (you'll have to leave them in place, or you'll have a gap in your dashboard), you'll need to be sure to reconnect the emergency flasher, which is located on the control strip. Good luck!
try looking at tss-radio.com these guys have everything you could ever want for sirius, even the radios!
As long as you use an OEM unit, it should plug right in with no modifications necessary.
No, radios have changed in 2 years. Check the radio before you change to see if it is the same.
It's under the center dash behind the oem radio
i dont know oem is original equipment manufacturer that means a factory installed radio
Exchanging an OEM single CD radio with an OEM 6 CD radio is a simple upgrade which requires the use of a proper wire harness to ensure radio usability. Once the stock radio is removed from the dash the 6 CD changer will plug right into the proper OEM wire harness.
OEM equipment modifies the audio from the radio, sends it to the speaker and converts it back to normal audio on the speaker frame ckt board. To put in an aftermarket radio, use two of the wires and connect up to your new speakers and radio to make use of OEM wire routing.
There are many places where one can purchase a Ford OEM radio for their car. One can purchase a Ford OEM radio for their car at popular on the web sources such as the official Ford website or Amazon.
front and rear door speakers are 6 1/2"....
Is this a new aftermarket radio? Either new or OEM I suggest you check the connections at the speaker and the back of the radio.
2006 Accord Coupe: Front doors - 6.5" speakers, Rear deck - 6"x9" speakers
It displays on the factory radio. There is a button on the OEM radio to either show the time or radio station.
All you need is an adaptor
Removing the radio from a 1990 Cressida is a pain, mainly because it is in three parts (radio/CD player, radio/CD player controls, and amplifier). First you remove the trim from the transmission shift area, then begin removing all the plastic items from around the radio and control strip, working your way up from the shift area. Note that you will probably not be able to replace the OEM radio --Toyota wants $2300 for one, but they don't have any. If you install an after-market replacement radio you'll have to rewire the speakers, because they are connected to the separate amplifier, located behind the radio on the firewall, which can only be controlled by the OEM system. Note also that if you install an after-market radio and you bypass the OEM radio controls (you'll have to leave them in place, or you'll have a gap in your dashboard), you'll need to be sure to reconnect the emergency flasher, which is located on the control strip. Good luck!
no you do not NEED a wiring harness its alot easier. I would probably put the speakers in the middle of the van on the doors.