The electromagnetic force is a force that is expressed as (or that "shows up as") a "field" or a "group of lines of force" around the source. Electromagnetic flux is a direct reference to those magnetic lines of force. Electromagnetic flux is the electromagnetic field or the group of electromagnetic lines of force around the source. All the following sentences say the same thing: The electromagnetic flux around the magnet was very high. The magnetic flux around the magnet was very high. The magnetic field around the magnet was very large. The flux around the magnet was very high. The field around the magnet was very large. There were a large number of magnetic lines of force around the magnet making the field strength very high.
they are directly proportional and are sometimes used interchangeably.. flux can be insolation , magnetic lines, electrostatic density, pressure... within a document they generally refer to the same entity if one is electric and one magnetic be careful to sort out which is witch
The SI unit of magnetic flux is the weber (in derived units: volt-seconds)
As current flow trough a wire by using the right hand rule of thumb a magnetic flux encircles the wire. if an adjacent wire are passive these lines of flux will generate an electron flow on that wire therefore the transfer is complete minus the efficiency of the transfer . Magnetics LINES varies as the square of the distance.
it is called the thumb rule right hand curled means flux line thumb means direction of current. there will be a reversal of flux.
Magnetic flux lines travel from the north pole of a magnet to the south pole.
Electro magnetic flux which is in maxwells and gauss.
If magnetic lines are close, then the magnetic field has a lot of magnetic lines of force packed together. This translates into a large number of flux lines per unit of area through which they're passing. A large number of flux lines per unit area means a high field density. High flux density means the magnetic field is strong compared to a field where the flux lines are not as close together.
No of lines of force can pass through the unit area of magnetic field
There is more magnetic force in that region on a particle.
The resistance of a substance to the passing of magnetic flux lines is called magnetic reluctance. It is analogous to electrical resistance in a circuit and is influenced by the material's properties and geometry. A material with high reluctance impedes the flow of magnetic flux lines, while one with low reluctance allows them to pass more easily.
1. The orientation giving the maximum magnetic flux would be 90 degrees or perpendicular to the magnetic field because that gives the maximum amount of magnetic field lines able to pass through the area of the coil. The greater density of field lines gives a greater magnetic field. The orientation that would give a magnetic flux of zero is the plane of the coil to be parallel to the magnetic field, making no lines pass through the coil and thus no flux.
By cutting lines of magnetic flux through an electromagnet
Magnetic flux
magnetic flux lines.
Magnetic lines of flux help align the magnetic domains in soft iron, increasing its magnetic permeability and making it easier for the material to become magnetized. This results in the material being strongly attracted to magnets and enhancing its magnetic properties.
There is more magnetic force in that region on a particle.