answersLogoWhite

0


Best Answer

The small cylindrical thing that You see (generally on a side of the choke coil) is the "starter " of the tube light. This is the capacitor used in tube light. And is used to provide a momentary voltage rise of nearly 400V to start up the tube light hence Starter.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

13y ago

it may store charge

Answer

To improve the lamp circuit's power factor.

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the position of capacitance of tube light?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Movies & Television

What do you call tube light in Telugu?

ట్యూబ్ లైట్


What is the effect of capacitance in high frequency circuits and how it is getting added?

First, capacitance is the resistance of something to a change in voltage. And capacitance exists anywhere there is a conductor that is insulated from another conductor. With that definition, anything has capacitance. And that's correct. It is also the key to understanding the capacitance in high frequency (radio frequency or RF) circuits. The fact that a circuit had conductive pathways and component leads and such means that there is a lot of little bits of capacitance distributed around the circuit. The capacitance is already there; it isn't "added" later as might be inferred. Normally, this bit of capacitance isn't a problem. But at higher and higher frequencies, it is. Remember that the higher the frequency of an AC signal, the better it goes through a given cap. So at higher and higher frequencies, the distributed capacitance in the circuit "shorts the signal to ground" and takes it out of the circuit. The RF is said to be coupled out of the circuit through the distributed capacitance in that circuit. The higher the frequency a given circuit is asked to deal with, the more signal will be lost to this effect. It's just that simple. Design considerations and proper component selection minimize the distributed capacitance in a circuit.


What is diffusion capacitance in pn junction?

A capacitor is a device that stores charge. Therefore any device that stores charges( static or dynamic) can be said to have capacitance. When a PN diode is forward biased, a current flows due to the majority charge carriers. At a particular instant there will be charges in motion. This is dynamic charge. The capacitance due to storage of dynamic charge is called the diffusion capacitance. We know that C = Q * V. That is capacitance is directly proportional to charge stored. Since the diode current increases exponentially with the voltage applied across it, the dynamic charge also increases exponentially . Hence the diffusion capacitance increases exponentially with the increasing diode voltage.


Difference between stray and parasitic capacitance?

Parasitic capacitance is unavoidable and usually unwanted capacity between two or more conductors which exists due to close proximity and which typically causes non-ideal circuit behavior. Stray capacitance, as it is typically thought of, is a type of parasitic capacitance. It is the capacity from a conductor to its surroundings which is the aggregate of the conductors in its environment inversely weighted by the distance to each of the environmental conductors.


What is 220uF?

It is unit of capacitance. 220 micro farad.

Related questions

Which tube was developed to compensate for the effects of interelectrode capacitance?

whict tube was developed to compensate for the effects of interelectrode capacitance


How does a tube light works?

tube light woks like a tube light....


How a tube light works?

tube light woks like a tube light....


What are the limitations of conventional tubes at microwave frequency?

2-3Figure 2-1B.-Interelectrode capacitance in a vacuum tube. 100 MEGAHERTZ.Figure 2-1C.-Interelectrode capacitance in a vacuum tube. INTERELECTRODE CAPACITANCE IN ATUNED-PLATE TUNED-GRID OSCILLATOR.A good point to remember is that the higher the frequency, or the larger the interelectrodecapacitance, the higher will be the current through this capacitance. The circuit in figure 2-1C, shows theinterelectrode capacitance between the grid and the cathode (Cgk) in parallel with the signal source. Asthe frequency of the input signal increases, the effective grid-to-cathode impedance of the tube decreasesbecause of a decrease in the reactance of the interelectrode capacitance. If the signal frequency is 100megahertz or greater, the reactance of the grid-to-cathode capacitance is so small that much of the signalis short-circuited within the tube. Since the interelectrode capacitances are effectively in parallel with thetuned circuits, as shown in figures 2-1A, B, and C, they will also affect the frequency at which the tunedcircuits resonate.Another frequency-limiting factor is the LEAD INDUCTANCE of the tube elements. Since the leadinductances within a tube are effectively in parallel with the interelectrode capacitance, the net effect is toraise the frequency limit. However, the inductance of the cathode lead is common to both the grid andplate circuits. This provides a path for degenerative feedback which reduces overall circuit efficiency.


What will be the name of tube light in urdu?

tube light


What is the full form of tube light?

tube light


What is full form of tube light?

tube light


What you call tube light in Telugu language?

A tube light is commonly referred to as "Tube Light" or "Tube Prakasham" in the Telugu language.


What is the urdu of tube light?

Well Word "Tube Light" is the combine of two different words 'Tube' & 'Light' Mean! Tube (نال....نالی) Light (روشنی- نور-چمک) so finally we can call "Tube Light" in urdu! "روشن نال"


Definition of a capacitance in mosfet?

Capacitance in mosfet is of three types: gate capacitance diffusion capacitance routing capacitance Gate capacitance: limits the speed of the device t which it can be operated Diffusion capacitance: It is the capacitance due to charge carriers between drain and source. Routing capacitance: It is the capacitance of the metal which is deposited on the top of oxide layer.


Is tube light translucent?

Yes, a tube light is generally made of a glass or plastic tube that is translucent, allowing light to pass through it. The tube is coated on the inside with phosphor to convert the electrical energy into visible light.


Circuits to light a fused tube light?

the two side fused tube light reuse is possible