it is used for prevention of over flow of current and for maintaining irrespective regulation
AnswerA resistance box is a piece of laboratory equipment consisting of an electrically-insulated box, containing a number of resistors which can be connected, externally, via a pair of terminals. The resistance can be adjusted in fixed amounts by inserting or removing metal pegs into a slotted bar; this arrangement either adds or removes the fixed resistors into the circuit.
Always put subject heading so that the person receiving the email can quickly see what the email is about.
This is relative to the purpose or application. 1 mega ohm may be considered "low resistance" when testing insulation levels; when testing a cable, 1 ohm may be too much. When testing substation ground grids, I believe 1 ohm is the maximum allowable value in some countries.
Voltage = (current) x (resistance) Current = (voltage)/(resistance) Resistance = (voltage)/(current)
99.99% silver is the best for no resistance.
(Electronics) Resistor placed in the emitter lead of a transistor circuit to minimize the effects of temperature on the emitter-base junction resistance and its resistance is called swamping resistance.
a box which has resistance between 1 ohm to 50000 ohm
Resistance doesn't have a 'purpose'; it exists whether you want it or not. You can modify it by adding more resistance in series or in parallel, but you can't avoid it!
The use of a resistance box or a "Decade Box" is to help calibrate instruments used to measure electrical values such as Voltage, Current, and Resistance. Without them you would not have a known value of resistance to use as a set point.
Resistance decade box is nothing but Resistance bank. It has various ranges of Resistance value ranging from few ohms to few mega ohms. In other terms, large value of resistance are fabricated in single box is said to be Resistance decade box.
we use it when we require a variable resistance in a circuit
It depends on what you want to accomplish. If you want to decrease the resistance in a circuit, you would place the box in parallel to some other resistor. If you want to increase the resistance in a circuit, you would place the box in series.
the purpose of the LRA is to turn the Uganda into a theocracy
to investigate change in resistance as temperature is varied
the purpose of it is it integrates schools
how to calculate resistance box for slipring motors
The wires in the resistance box are double folded to reduce their resistance value by a factor of 4, as resistance is inversely proportional to the cross-sectional area of the wire. This allows for more precise resistance increments to be achieved by varying the length of wire exposed in the circuit.
u & yo mamma