0
Add your answer:
Earn +20 pts
Are pumpkin cookies drop cookies?
It depends on the recipe. There are recipes for pumpkin drop cookies, and there are other recipes in which the cookies are rolled and cut with cookie cutters.
When was Talking Threads created?
Talking Threads was created on 2009-10-14.
What is bolt threads?
The Threads on a Bolt are the ridges or grooves that screws into a Nut or into a metal frame or such.
What are the ratings and certificates for Strangling Threads - 1923?
Strangling Threads - 1923 is rated/received certificates of: UK:U
What are the release dates for Threads of Hope - 2010?
Threads of Hope - 2010 was released on: USA: 8 October 2010 (limited)
Do you need s special tool to cut bike spokes?
Depends on whether you're talking about cutting threads in them or merely about cutting them off. Cutting threads in the does require a special tool as spoke threads aren't cut but rolled. Using a die cutter is awkward and likely to result ina weaker thread. If your intention merely is to cut them off then any thread cutter strong enough to deal with steel will do the job. Don't get one intended for electrical (copper or aluminum) cable, as the steel spokes will damage those shears.
What is a tapping hole?
is when you re-cut the threads in a bore using a die tool that is struck and then turned to make the threads
What tool is used to cut threads inside a hole?
A. Tap
What is a thead tap used for?
Assuming you mean "thread tap", it is for cutting new threads in a hole.
How do you cut external threads using hand dies?
Ask dell -__-
What are rolled cookies?
rolled cookies are usually a type of cookie that is rolled out with a rolling pin, and then used to cut into different shapes, etc. It is usually a stiffer kind of dough, such as a sugar cookie consistency.
What tool should be used to cut virgin threads on a steel shaft?
A Die
What tool can be used to cut external threads on bolts or rods?
with a pair of scissors
How come threads cannot be rolled on gray cast iron?
Because grey cast iron is not malleable, it has a crystalline structure that cannot be reformed cold.
When you need to cut new external threads on a bolt what tool should you use?
A. a die
When lathe cutting threads how do you measure external screw threads to know they have been cut deep enough?
The only sure method is to have the appropriate internal (female) thread eg. a nut available and to try this on the cut thread. If the fit is too tight then another cut or pass must be made on the lathe. If you are cutting both male and female threads to match then cut the female thread first and use it to check the cutting of the male thread. Submitted by Bill Lavery
What is meant by pitch measurement in lathe?
Pitch measurement refers to the distance from one thread to the next when threads are cut on a lathe. Different threads have different pitches and a lathe can be set to to cut to any specified pitch. This is achieved by selecting the pitch and engaging the lead screw on levers located on the headstock, then engaging the half-nut around the lead screw from the apron. With the correct threading tool inserted threads can be cut into the workpiece.
