0
If you need to repair something and you don't have the exact size of sockets or adapters, you can use a socket adapter to get the job done. Socket adapters can be attached to any type of socket to get the perfect size that you need to make a bolt tighter or loosen a bolt. You can use a socket adapter on almost any type of electronic or other item that has screws and bolts. Be careful when you tighten the bolts though because if you get it too tight or if your cross thread it, you will ruin the bolt and need to get a new one.
Add your answer:
Earn +20 pts
What are use of wrench?
For undoing and tightening nuts and bolts.
Head bolt tightening sequence for Mazda e2000?
Begin by tightening the head bolts on each corner of the head. Next, tighten the center head bolts. Tighten the bolts on each end of the head and move towards the center.
Honda d15b2 head Tightening Sequence?
The Honda had bolt tightening sequence begins with the head bolts on each end of the head. Tighten the head bolts moving to the center, alternating from and to end.
Cylinder head tightening sequence for Vauxhall Vectra?
The cylinder had bolt tightening sequence should begin by tightening the head bolts on each end of the head. Tighten the center head bolts. Work towards each end of the head, alternating back and forth.
What is a typical day of a car technician?
loosening and tightening nuts and bolts
What sort of machine is a wrench?
A wrench is a lever for tightening or loosening bolts .
What do you spanner for?
You can use spanners for :- Gas Repair, Plumbing, Tightening bolts.
What is the tightening sequence for head bolts on a peugot 106 1.1?
The tightening sequence for the head bolts on a Peugeot 106 1.1 is to begin at 1 and of the head. Move to the opposite end of the head. Alternate back in forth until you reached the middle.
How do you install cylinder head bolts on a 1996 Saturn?
What are the torque specifications and the tightening sequence of the cylinder head bolts on a 1996 Saturn SL1?
What do you use spanners for?
for workshop use
What is the order of tighten of the head bolts?
The head bolts should be tightened in a specific sequence to ensure even distribution of pressure on the head gasket. Typically, this involves tightening them in a criss-cross pattern starting from the center and working outwards. It's important to consult your vehicle's service manual for the exact tightening sequence and torque specifications.
What is the torque and tightening pattern when using old bolts to replace the head gasket on a 1989 Chevy S-10 2.5?
You cannot use the old bolts to retorque the heads. They are torqure to yield bolts. You must get new bolts.
