Harley air cleaners can be purchased from many online stores. Some examples of stores that sell Harley air cleaners include J&P Cycles, Bike Bandit, and Cruiser Customizing.
Normally if it's coming out of the air cleaner, it's either the filter or a bad seal. But in my case it wasn't either. Turns out one of the bolts on my oil pan cover was loose. I put on some thread lock and crancked it back in. Hopefully that fixes it.
PVC valve
The air filter/cleaner is behind the headlight on the driver's side. The MAF sensor is in the air tube behind the air cleaner with wires coming out of it.
You need to rebuild that carb, there should never be that much fuel coming out of the jets.
Coming Up for Air - Kayak album - was created in 2008.
They mean running the motor without an air cleaner. Some people used to run open carbs on street bikes but even if nothing big gets in there, engine wear is accelerated.
There are several ways. First step would be to change your jets, air cleaner assembly and exhaust. Or do like I did and replace your carburetor with a performance unit with an upgraded air cleaner assembly and install an aftermarket exhaust system of some kind.
July 16th, 2008
First try to locate the air cleaner assembly. Once this is found, locate the air hose that leads to the carburetor from the air cleaner assembly. Disconnect this hose from the air cleaner assembly and the mass airflow sensor will be visible right at the outflow mouth of the air cleaner assembly. The intake air temperature sensor is located as a component part of that mass air flow sensor.
Round plastic knob right below air-cleaner.
There is a small chrome breather tube going to the air cleaner from the oil tank. After the bike sits all the oil drains down to the tank and when you first start the bike because of the low volume oil pump the some oil goes through the breather and into the air cleaner. you can go to a dealer they have a kit to fix that problem.