0
Why does your motorcycle sputter when giving it a lot of gas However shutting it off and starting it up again it runs fine. Why?
Wiki User
∙ 16y ago
Sounds like the carburetors could be clogged or dirty. When you give it gas, it is opening up and sucking more fuel in.. so if it sputters, that means there is a clog or dirty gas. You may also want to check the air filter and if you are mechanically inclined, try taking off the carb and soak it in gas to clean the debris out. Then put them back on after a few hours.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Your 02 trailblazer is starting to sputter?
take off throttle body and clean it with throttle body cleaner.
1990 4x4 Dakota 39 why sometimes when starting it spits and sputter badly until it warms up then is fine until you have driven 35 miles then it starts to spit and sputter wants to die?
have the fuel pess. checked
What causes a motorcycle to sputter while riding?
When u ride gas isn't getting the engine as efficient as it should so there might be a clog in ur fuel line or the carborator might need cleaning
Can you give me a sentence with sputter?
After the repair, the engine began to sputter and emit black smoke.
What would cause 1999 dodge neon to sputter and hesitate starting out and in between gears replacing transmission did not solve?
Check the catalytic converter for leaks.
Why does your Camaro sputter when i accelerate but not all the time?
My camero doesn't sputter ever, even when you accelerate.
What rhymes with sputter?
shtter
What are the antonyms for sputter?
go to antonyms.com....
What causes the rototiller to sputter?
seaweed is
What makes a car sputter?
A malfunctioning battery can't provide enough power to your ignition system when the motor is idling can cause sputtering. If there is not enough gas, that can cause your vehicle to sputter. If the spark plugs fail to fire will also cause your vehicle to sputter.
Why does your yfz 450 sputter?
Bad Jetting
Why there is low deposition rate in sputter deposition?
Low deposition rate in sputter deposition can be attributed to factors such as low sputter yield of the target material, insufficient power or pressure to sustain sputtering, inefficient target utilization, or poor target-substrate geometry leading to inefficient material transfer. Increasing any of these factors can help improve the deposition rate in sputter deposition.
