With the bike on the center stand, right side ( foot brake ) look under and in the rear of the engine. There is only one bolt in that place. Filter in the front casing with the ribs on it. There is a boss on the casing that fits the two lines on the block. There are two 0-rings to change, comes with the kit, watch how it comes apart, there is a spring and washer in there with the filter. Takes 3.2 Liters or 3.4 U.S. quarts. 20w40 Motul is good.
how to change oil in a 1986 honda gold wing motorcycle
The oil drain plug is on the front of the motor below the oil filter.
10w40 will do just fine. I use Motul.
On the right side there is a chcek glass it is hard to see
If you look at the diff. you will see a drain plug and a re-fill plug. Check with your local dealer for the right oil.
Take front fog cowling off. remove drain plug, and remove oil filter.
Oil drain plug is located at the back of the engine, right side, ( foot brake side ) towards the bottom of the engine.
Under oil filter, a little to the right. 17M size head on bolt. Look under radiator.
The oil drain plug is located on the underside of the engine directly below the filler hole. The head of the bolt will need a 17mm socket to remove.
With the filter changed. 3.2 liters. If the engine was taken apart that would then be 4 liters.
Right side, around the foot brake, just beside the dip stick. Can't miss it.
There is a plug on the engine right beside the oil filter. This will drain the engine and rad. Or, just remove the lower rad. hose at the thermostat.