where to put transmission fluid at in 93 ford areo star
A Mopar special tool and a star scan is required to check the transmission fluid
No , the 2002 Ford Windstar Owner Guide shows Motorcraft MERCON - V - automatic transmission fluid in the automatic transaxle
well you might need to add more transmission fluid you might even have to drain your intire transmission of the fluid it has now and put more in the transmission.
Try changing transmission fluid - inexpesive first step Transmission may need internal service
the transmission fluid is only in the tranny. the eight point star shaped cap the previous answer to this wuestion is the res. for the power steering pump. PS pumps use atf oil
you put the fluid in the dip stick hole, at least that is how it is on my ford aero star
Read your owner's manual you can check the fluid level on bottom of pan with #30 star bit to add fluid you have to have fluid pump to put fluid in bottom plug on pan
A Mopar special tool and a star scan is required to check the transmission fluid in any of the newer model dodge, chrysler, and jeeps. The fluid level is very temperature sensitive It is impossible to get the level correct with out a scan tool.
There's a star-shaped cap behind the battery (closer to the windshield) on the driver's side of the engine compartment. That's where the power steering fluid goes (I use dexron III automatic transmission fluid).
Ford specifies a high quality DOT 3 fluid. Do not put any other fluid in the brake system as it will cause damage and may make the brakes inoperative.
It is just to the right of the radiator hose, under the air filter assembly. You will need a star-bit to take off the assembly and you will see a cap labeled "Trans Fluid"