Choke Cleaner
Yes and on all the linkage.
use a can of carburater cleaner
Carburetor cleaner is a chemical spray which is used to remove buildup and deposits from carburetors. It is designed to safely clean without damaging the surface.
yes,it is the same.
Clean the injectors
I like to spray carb cleaner on a lint free rag to clean out most of the intake first but you can spray some inside just try to get most of it out if you sprayed alot inside wait a few minutes so it can evaporate before you start your car just incase it ignites.OTMAN Carburetor cleaner is designed to remove heavy varnish and gunk from the inside and outside of a vehicle's carburetor. If the carburetor is not cleaned periodically, it will begin to affect the vehicle's mileage and performance. The carb should be cleaned a couple of times a year to prevent buildup and keep the engine running smooth.Remove the air cleaner unit from the engine by unscrewing the wing nut. You might need pliers to turn the wing nut if it is very tight.Vacuum off the top of the engine area to prevent dirt and debris from being sucked into the engine while the air cleaner is not in place.Spray the entire carburetor inside and out with carburetor cleaner to loosen the gunk and varnish. Use shop rags to wipe up any heavy grease and gunk loosened by the carb cleaner.Start the vehicle. With the vehicle running, spray carburetor cleaner down the throat of the carburetor and around the outside. The engine will pick up a bit as the vehicle burns the carburetor cleaner. Wait a few minutes and shut off the engine.Spray the outside and inside of the carburetor again heavily. Start the vehicle again and spray more carb cleaner around the outside and inside while the engine is running.Spray the entire air cleaner inside and out with carburetor cleaner. Wipe the air cleaner dry with shop towels. Install a new air filter element and re-install the air cleaner unit onto the carburetor.
Just spray some carburetor cleaner into the carburetor and then let the car idle for a bit. In addition to the above answer add a can of Seafoam or Techron fuel system cleaner to a full tank of fuel once each year.
your float is stuck in the carburetor. Clean it with carb cleaner.
Top of engine under air cleaner
on top of the engine, under the air cleaner
carburetor cleaning spray will dissolve old oil and gas tarnish build up in a carb, but it will not remove dirt and grit that has got into the carburetor. Very interesting information here. I have been a carburetor re builder for over 20 years and have found the best method of professional carb cleaning is to use a ultrasonic cleaner.