its basically the check engine light and should be checked out immediately
what is the front fork oil capacity for showa upside down forks on a 1997 suzuki 750cc gsxr? what is the front fork oil capacity for showa upside down forks on a 1997 suzuki 750cc gsxr?
yes! they are the same
what size light bulbs for the front headlight on a gsxr 600 take? i want the hyper blue lights. or where can i order them from? you can order a HID setup for a great price from DDMTUNING.com you will want a 12k bulb for the blue look
Most late GSXR750 have the battery under the front seat.
16 teeth in the front 45 teeth in the rear
You cannot modify a 2007 GSXR motor in a 2004 GSXR frame.
at the front of the bike, should be factory mounted on the gauge bracket. also there are some fuses under the tail fairing, left side of the seat
i would fit it by not being shy about taking the front of the bandit.and then attempting to mount the gsxr 1000 front end in the bearing hole .make sure the bearings have no loose play of course.i would try to mount the gsxr bearings with the front if it fits.then tighten the main bolt to specs.if it feels rite then use the handlebars ,and brakes from the gsxr,i would also buy or use the gsxr rim with calipers. Bleed your brakes,check over everything 100 times for safety.mount all your handlebar electronic switches and throttle.basically just take it apart and reassemble with your gsxr front.If you cant do it you can put the original back together.Check out a magazine called Streetfighters printed in U.K. the mag costs $9.99 at the local mall book store.they do alot of these swaps.
Afraid not I have a 2000 GSXR 750 and it sits very proud. The small tongue like fixing point on the back end of the seat is too short. The retaining bolts on the front are too short they don't reach down enough
The main low beam should be an H11!
No, not just bolt on and go, get the rear spacer from the gsxr wheel and install rear wheel with that spacer and remove te stock one that's on the Busa, then mill .125 off the rear brake caliper hanger so it tightens to the wheel.. as for the front you'll need the gsxr 1000 rotors too, as well as spacers from the gsxr for them to fit a Busa.