if its the front caliper its easy first remove the caliper (this is because when the caliper is in its normal position on the bike only fluid runs out and not air) then put a peice of wood in-between the pads (this peice should be as thick as the brake-disk) hold the calliper so that the bleeding nipple faces the upward position now ask some-one to pull the brake lever then as he pulls the lever to its full compression then open the nipple (the nipple is a size 6 wrench) so fluid and air comes out the close it quickly befor it sucks air back into the caliper and keep doing this antill the brakes are hard then put the calliper back on the bike and ride.......then for the back wheel its the same as above but you just have to remove the rear wheel
a cr 250 will go 120 mph. i have and enjoy riding 120 mph it is so fun ;)
85,95
Yes, it will fit and do fine! 1986 - 1991 are the same cranks.
the Honda cr 250 is alot faster on take off up to its topspeed but the 4 strokes are usally faster at top end but it depends the gearing
A CR 250 is a Honda 2 stroke motocross bike.Ooops, forgot that Husqvarna also has a CR 250, also a 2 stroke motocross bike.
Any dot 3 is fine for all cars. the important thing to remember is not to mix synthetic with regular. Just don't get the synthetic stuff by mistake, or you'll have to bleed the brakes.
hello how much horse power is A STANDARD cr 250 1991 , the engines are the same from 89 to 91 thanks alot johnny
ngk b9evx
32:1
Yes they are
42.68 kW or 58 HP
45.5