0
Add your answer:
Earn +20 pts
Where is the battery located on a Kawasaki mule?
When changing your battery on your Kawasaki mule, it is best to take careful precautions. To ensure that you have the proper procedures and location, seek the advice of a certified Kawasaki mechanic.
How do you adjust the drive belt on a 610 kawasaki mule?
Take it to your nearest certified Kawasaki dealer...
What kind of oil does a kawasaki mule take?
Motor Oil
How much oil does a Kawasaki mule take?
1.9 quarts or 1.8 litters with filter change 1.6 quarts or 1.5 litters with out filter removal
How much oil will a 1996 kawasaki bayou 300 ATV take?
3-4 quarts
How much transmission oil does a 2007 kawasaki kx250 take?
850ml, its stamped on the side of the crankcase.
What type of oil does a 2003 kawasaki ninja 636 take?
What kind of oil dose a 03 kawasaki 636 take
How do you replace the drive belt on a kawasaki mule 2510?
You need a special tool from Kawasaki to hold the drive pulley. The Kawasaki part number for the tool is 57001-1520. After you remove the convertor cover. You remove the drive pulley by bolting the tool on the three upper bolts then take off the drive pulley nut (left hand threads). Once the pulley is off take the belt off the driven pulley then you can reinstall the new belt. You also have to check the belt deflection. Put a straight edge from the belt on the drive pulley to the belt on the driven pulley. Using a ruller push down on the belt. The deflection should be no more than 1". If it is I would take the ATV to a Kawasaki dealer. They will need to add or subtract springs and shims from the drive pulley. If the old belt has never been change you might be OK by just replacing it. I have not tried to take the drive pulley off without using the special tool from kawasaki. The best thing you can do is go to RepairManuals.com and look up a KVF650 2003, you can buy the OEM repair manual for $60.00 plus about $6.00 shipping. It has saved me a lot of money.
How do you replace rear wheel bearings on kawasaki mule 2510?
I have a 1997 mule 2510 You have to remove the whole rear end of it to replace the rear bearings because the bearings are inside the housing on the cv joint. The axle bolts in the rear diff with six bolts. you take the shocks and springs and all loose and drop the whole rear end and the and take the top part of the axle off the bottom half axle and then you will see the bearings
How much oil does it take to change a kawasaki bayou 220?
it takes 2 quarts to change a 1998 bayoe 220
How much oil does a 15 hp kawasaki lawn mower engine take?
Kawasaki 15 HP Ariens Lawn Mower takes 1.2 Litres of oil and maybe a little more when you change the oil filter
How much engine oil does a kawasaki ksf 250 four stroke quad need?
Most models take 2 Liters.
