I can only speak for a YFZ450 04-05, the engines are the same. There is no gear oil in a YFZ450. Weird I know. The engine oil tank right in front is black usually has a gray cap. That tank supplies the gears as well as the engine. If you follow the silver pick up line on top of the black oil tank it goes to the left side of the bike where the gear shift lever is. To change the oil you will want to remove the bolt on the bottom side of the black oil tank, then remove the bolt right under the gear shift lever this will drain the oil in the gear case. The bolt is the only 12mm bolt on that side. Many people miss this step and will over fill or under fill the oil tank which will cause a knocking sound in most cases. Once you have removed both bolts lean the bike to the left. (if you are sitting on the bike it would be your left). Then remove the oil filter this is on the right side of the bike. Never place a dry new oil filter in the bike, take some oil and wet the new oil filter as well as the rubber seals, place new filter in and bolt on the cover. Now that the oil is drained screw the bolts back in. One in the oil tank and one in the case right under the gear shift lever. Remove the black cap on the case its a thumb screw type. It looks just like the gray one that goes on the oil tank. At this point you should have your new oil filter in and both screws back in the bike one in the bottom of the oil tank and one in the case right under the gear shift lever. The bike will take 2 liters of oil. I use maxima racing oil synblend 4 high performance 4 cycle oil sae10w40, its a 50/50 syn blend. I pour 1 liter into the black oil tank in the front and 1/2 of the second liter into the gear case. You will now have 1/2 a liter left. Start the bike let it run for a minute. Check the oil level on the black oil tank the gray cap acts as a dip stick. If low add oil. Now pour the rest of the oil into the gear case. Place caps on the oil tank fill hole and the gear fill hole. You bike should have 2 liters of oil in it. Your gear oil and bike oil change is done. Start the bike let it run, drive it slow so all the seals and oil filter setup.
650 ml.
near the oil filler somewhere on the cover it will say how much you need to put in
hw much gearbox oil do you put in your ktm 525
hey there wanted to no if any1 new how much gearbox oil i should put in my kx250 2005 moddle
I think 700 cc or .7 Liters
14 litres
Well, my friend, when it comes to filling up the gearbox of a 1998 Rav4, you'll want to look in the owner's manual for the specific amount recommended by the manufacturer. It's important to follow their guidelines to keep your vehicle running smoothly and ensure everything is properly lubricated. Just take your time, follow the instructions, and your Rav4 will be purring like a happy little engine in no time.
There should be a Phillips Screw on the side by the kick start remove screw and fill until oil comes out
The gearbox oil is separate from the engine oil on a 2002 1.4 Astra, and much thicker.
how much oil is usedinan automatic gearbox for a toyota vitz 1000cc
The 1993 Toyota Camry gearbox holds nine quarts of gear oil. The manufacturer recommends that you never overfill the gearbox.
500ml.